PULLEY, MOTOR, DAMPER
(PULLEY)
1 |
2 |
3 |
(MOTOR)
Damper
Hinge,
Damper
(DAMPER)
Remove the back cover.
Take off the belt turning the pulley.
Unscrew the bolt to pull out the pulley.
Unscrew 2 screws from the bracket.
Push the motor in the arrow direction for disassembling.
When reassembling the motor, make sure that motor mounting bushings are not taken off from the bracket.
Pull out the hinge, pressing its snap.
Do not use the pulled out hinge again. It may be taken off during operation.
Clean the drain pump filter
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
1 |
| 3 |
|
| |||
2 | |||||||
|
|
| |||||
Open the lower cover cap ( ) by | Unplug the drain plug ( ), then the | ||||||
using a finger Turn the drain plug ( ) | water flows out, |
|
| ||||
to pull out the hose. | At this time use a vessel | ||||||
|
|
| to prevent water flowing on the | ||||
|
|
| floor. If the water does not flow any | ||||
more,turn the pump filter (
) open to the left.
3
2
Take out any foreign material from the pump filter ( 
). After cleaning, turn the pump filter(
) clockwise and insert the
drain plug ( 
)to the original place. close the lower cover cap.
30