Installation
UNPACKING
•Do not attempt to operate the machine while any of the packaging is still in place.
•Remove all packaging and dispose of it in a responsible manner.
•Open the
POSITIONING
•The machine should be installed in a well ventilated place, away from direct sunlight.
•Hot and cold water taps should be located within 1 metre of the inlet valves at the rear of the machine.
•Positioned the machine on a flat and stable uncarpeted
floor capable of supporting the fully loaded washer.
•An adjustable levelling foot is located at the right, lower front of the machine and may be turned in or out to achieve stability. An unstable machine will vibrate and generate excessive noise.
•A plastic noise reduction panel is attached to the rear of the machine. Remove this panel, tilt the machine for- wards and slide the panel it into the retaining slots on the base as per the directions engraved on the panel.
CONNECTING THE WATER INLET HOSES
•Connect the inlet hoses to threaded hot and cold water taps and to the machine’s inlet fittings. Take care not to confuse the hot and cold water inlets. The hot water inlet is col- oured pink and the cold water inlet is coloured blue.
•If only one water tap is available, connect the inlet hose to the blue, cold water coupling.
•Open the taps and check for leaks.
ELECTRICAL INSTALLATION
•The washing machine is designed to operate on a 230 Volt, 50 Hz, 15 Amp, AC power supply.
•The machine should be connected to an earthed 3 pin wall socket.
•If the
The appliance must be
earthed
and the manufacturer
and seller
do not accept respon-
sibility for
any damage due to in-
correct
electrical connection.
Page 4