Operating Instructions
Washing Cycle Complete/Removing the Washing
Once the washing program has come to an end, END illuminates on the program progress display.
If RINSE HOLD was selected, the indicator beside the START/PAUSE button flashes.
0 1. After a RINSE HOLD, the water must first be pumped out:
–Press either the START/PAUSE button (the washing will be spun in accordance with the program which has just been completed; the spin speed can also be changed during spinning using the spin speed/ RINSE HOLD button),
or
–turn the program selector to (PUMP OUT), and press the START/PAUSE button (the water is pumped out without spinning),
or
–turn the program selector to SPIN or SHORT SPIN, and press the START/PAUSE button (the washing will be spun or short spun).
At the end of this program step, the END indicator will illuminate.
2.Open the door.
As soon as the DOOR indicator is green, the door can be opened.
3.Turn the program selector to OFF.
4.Remove the washing.
5.Close the water tap.
6.Pull the detergent drawer out a little after washing so that it can dry out. Leave the door ajar so that air can circulate in the washing machine.
3If the OVERDOSING indicator illuminates, then too much detergent was used in the washing program just completed, and as a result an addi- tional rinse performed. Next time you use the machine, observe the detergent manufacturer’s dosing instructions for the load to be washed!
Important! If the washing machine is not to be used for a long period: close the tap and isolate the washing machine from the mains.
24