Installation and Connection Instructions
Inlet Hose Connection
Important! This appliance must be connected to the cold water supply only.
The inlet hose provided is 1.2 or 1.3 metres depending on the model. If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length.
The rubber washers are either set into the inlet hose threaded connec- tion or supplied separately in the installation kit. These washers must be fitted to ensure water tight seals. Do not use any other washer.
0 1. Connect the hose to the machine with the right angled connector.
Important! Do not overtighten the plastic nuts on the threaded connectors.
2.Connect the hose end with a straight connector to the water supply tap with an 3/4" thread.
Important! Do not overtighten the plastic nuts on the inlet hose threaded connectors.
WARNING!
Open the water taps slowly and check the connections are watertight before final positioning of the machine.
Rubber Washer
Rubber Washer 
Fine Filter
48