Electrolux EW 1013 I manual At the end of the programme

Page 10

7.At the end of the programme

The machine stops automatically.

If the RINSE HOLD option has been selected, the machine will stop with the water left in the tub, to prevent the fabric from creasing.

To drain only, select the drain programme “P”.

To drain and spin, depress the RINSE HOLD button again.

The door is controlled by a safety device which releases 2 minutes after the end of the programme.

Switch the machine off by depressing the ON-OFF button again. The mains-on light goes out.

Remove the laundry from the drum and carefully check that the drum is empty.

If you do not intend to carry out another wash, close the water tap.

Leave the door open to prevent the formation of mildew and unpleasant smells.

10

Image 10
Contents Instruction Booklet Child Safety InstallationUse Contents Ecological hints Your New Washing MachineInterest Environment Description of the Appliance Child safety featureDetergent dispenser drawer Control Panel Operating Sequence At the end of the programme Start the programmeTo drain and spin, depress the Rinse Hold button again Select the required programme At the end of the programme Washing Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing Programmes Wash programme Degree of soil Programme Description Washing symbol Type of laundryLoad Maintenance and Cleaning Cleaning the water inlet filter Emergency emptying outSomething Not Working 0870 5 Service & Spare PartsSymptom Possible causes Customer CareEuropean guarantee Guarantee ConditionsStandard guarantee conditions This guarantee does not coverInstallation Instructions Technical SpecificationsUnpacking Installation on a Suspended FloorPositioning Appliance must be connected to a cold water supply Water inletWater drainage Into a drainage standpipeInterest of the environment LevellingSpecial conditions Onto a sink outlet spigotElectrical connection Permanent connectionPreparation and assembly of the door Building-inDrill four fixing holes see Fig. G