Electrolux 86741 manual Washing cycle complete/Removing the washing

Operating Instructions

Washing cycle complete/Removing the washing

Once the wash programme has come to an endm the END indicator il- luminates on the programme progress display.

•If the EASY IRON programme was selected, and anti-crease phase of approximately 30 minutes follows the programme end. Here, the multi display shows the remaining time and the END indicator illumi- nates. During the anti-creasing phase, the door can be opened at any time and the washing can be removed.

•If RINSE HOLD was selected, the display next to the START/PAUSE button flashs.

01. After a rinse hold, the water must first be pumped out:

–Either press the START/PAUSE button (water is pumped out and the washing is spun according to the completed programme; using the RINSE HOLD spin speed button, it is possible to change the spin speed during spinning),

or

–Turn the programme selector to DRAIN and press the START/PAUSE button (the water is pumped off without spinning),

or

–Turn the programme selector to SPIN or SHORT SPIN and press START/ PAUSE button (water is pumped out and the washing is spun accord-

ingly).

After the end of this programme step, the END display lights up.

2.Open the door.

As soon as the indicator next to the DOOR/LIGHT button is green, the door can be opened (not if programme security is activated. For details see „Programme security„).

3.Remove the washing.

4.Turn the programme selector to OFF.

5.After washing, pull the washing detergent drawer out a little so that it can dry out. Leave the door ajar so that air can circulate in the drum.

3	If the OVERDOSING indicator illuminates, then too much
	detergent was used in the washing programme just
	completed. Observe the dosing recommendations of the
	detergent manufacturer as well as the load quantity for the next wash.
	Important: If the washing machine is not to be used for a long period:
	Close the water tap and disconnect the washing machine from the
	electricity mains. (Anti-flood: The Aqua Control with Aqua Alarm does
	not function if the power supply is interrupted).

26