Electrolux 86741 manual Been removed Connection instructions

		Operating Instructions
Problem	Possible cause	Remedy
	Transport packaging has not	Remove transport packaging
		according to setting up and
	been removed.
		connection instructions.
		Adjust the feet according to
	The machine is not level.	installation and connection
		instructions.
Washing machine vi-	There is very little washing in	This does not affect the op-
brates during operation
	the drum (e.g. only a dressing
or is unstable.	gown).	eration of the machine.
	Water could not be fully	Check the drain hose and re-
		move any kink if necessary,
	pumped out before spinning
		or clean the drain pump and,
	because the drain hose is
		if necessary, remove foreign
	kinked or water pump is
		bodies from the pump hous-
	blocked.
		ing.
		If may be necessary to re-
Excessive foaming dur-	Probably too much detergent	duce the amount of deter-
		gent used. Follow the
ing the main wash.	has been used.	detergent manufacturer’s
		recommendations.
	The screw Connection on the	Tighten the inlet hose screw
	inlet hose is leaking.	connection.
	Drainage hose is leaking.	Check the drain hose and re-
		place it if necessary.
	The drain pump cover is not	Close cover correctly.
	correctly close.
Water leaks out of the	Washing is caught in the	Stop the programme, remove
washing machine.		the washing caught in the
	door.
		door. Restart the programme.
		Close the emergency empty-
	The emergency emptying	ing hose (see section „Carry
		out emergency emptying“).
	hose is not correctly closed
		Call your local Service Force
	or is leaking.
		Centre if the emergency
		emptying hose is leaking.

33