Installation and Connection Instructions
Installation-Site Preparation
•The installation surface must be clean, dry and level.
•Do not install on deep pile carpet.
•If the appliance is installed next to heat source (e. g. cooking appli- ance), a heat insulating pad (85 x 57 cm) must be placed between the washing machine and the heat source.
•Do not install the appliance in locations where the temperature may fall below freezing.
•Please ensure that when the appliance is installed it is easily accessi- ble for the engineer in the event of a breakdown.
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable.
Levelling the Appliance
3Self adjusting foot: The back right foot of your washing machine is designed like a spring leg. This makes the machine very stable even at high spin speeds.
If the washing machine is not stable proceed as follows:
0 1. Set the three adjustable feet to length of 10 mm. Use the supplied spanner.
If the self adjusting foot does not reach to the floor:
2.Manually extend the self adjusting foot to the required length.
3.Check the appliance is level using a spirit level.
Important! Never use strips or shims of wood or cardboard etc. to compensate for any uneveness in the floor. Always use the adjustable feet.
44