Electrolux EWS 125410 A, EWS 105410 A Troubleshooting, Emergency Drain, Frost Precautions

Page 15

4.Install again the inlet hose. Make sure that the couplings are tight to prevent leakages.

5. Open the water tap.

EMERGENCY DRAIN

Because of a malfunction, the appliance cannot drain the water.

If this occurs, do steps (1) through (5) of 'To clean the drain pump'.

If necessary, clean the pump.

When you drain the water with the emer- gency drain procedure, you must activate again the drain system:

1.Put 2 litres of water in the main wash compartment of the detergent dispens- er.

electrolux 15

2.Start the programme to drain the wa- ter.

FROST PRECAUTIONS

If the appliance is installed in an area where the temperature can be less than 0 °C, re- move the remaining water from the inlet hose and the drain pump.

1.Disconnect the mains plug from the mains socket.

2.Close the water tap.

3.Remove the water inlet hose

4.Put the two ends of the inlet hose in a container and let the water flow out of the hose.

5.Empty the drain pump. Refer to the emergency drain procedure

6.When the drain pump is empty, install the inlet hose again.

Warning! Make sure that the temperature is more than 0 °C before you use the appliance again.

The manufacturer is not responsible for damages caused by low temperatures.

TROUBLESHOOTING

The start of the appliance does not occur or it stops during operation.

First try to find a solution to the problem (re- fer to the table). If not, contact the service centre.

With some problems, the display shows an alarm code:

•E:00 - The appliance door is open or not closed correctly or it does not fill with wa- ter.

•E:01 - The appliance continuously fills and drains the water or it does not drain or do the spinning phase.

•E:02 - Technical malfunction, contact the service centre.

•E:03 - Technical malfunction, contact the service centre.

Warning! Deactivate the appliance before you do the checks.

Problem		Possible cause
The appliance does not		The mains plug is not connec-
start.		ted in the mains socket.
		The fuse in the box fuse is
		damage.
		The appliance door is open.
		You do not press the start but-
		ton

Possible solution

Put in the mains plug.

Replace the fuse.

Close the door firmly.

Press the start button.

Image 15

Contents Washing Machine Safety Information ContentsEcological Hints Environment ConcernsDiscard the Appliance Packaging MaterialsProduct Description Technical InformationAccessories Control PanelProgramme Knob Easy Iron Button Delay Start ButtonDisplay C D Start ButtonProgrammes Type of load and soil Weight of loadStandard programmes for the Energy Label consumption values Consumption ValuesDetergents and Additives Hints and TipsLaundry Load Stubborn StainsLoading the Laundry Using the liquid detergentBefore First USE Daily USECancel the Delay Start Setting and Starting a ProgrammeCancel a Programme SET the Delay StartCare and Cleaning Clean the pump if Detergent DispenserDrain Pump Clean the Inlet Valve Filter Emergency Drain TroubleshootingFrost Precautions With some problems, the display shows an alarm codeProgramme knob is not Unpacking InstallationService We recommend that you write the information hereElectrolux Inlet Hose Install the appliance on a flat hard floorThere are different procedures to connect the drain hose Positioning and LevellingWith the plastic hose guide On the edge of a sinkWithout the plastic hose guide Electrolux Electrolux Electrolux 155219270-A-352011