Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing ma- chine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. If necessary, check the set- ting with a spirit level. Any necessary adjust- ment can be made with a spanner. Accurate levelling prevents vibration, noise and dis- placement of the machine during operation.
Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
electrolux 21
Water inlet
Warning! This appliance must be connected to a cold water supply.
1.Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance.
Important! Do not use the hose from your previous machine to connect to the water supply.
2.The other end of the inlet hose which connects to the machine can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the hose to the left or right depend- ing on the position of your water tap.
3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is too short and you do not wish to move the