Description of the appliance
Display
The display shows the following information:
•If the programme selector dial is on the RESET position, three flashing dashes appear immediately after pressing the ON/OFF button to indicate that the machine is ready to be selected for the required wash programme.
•Duration of the selected wash programme, calculated automatically on the basis of the maximum recommended load for each type of fab- ric.
•When the programme has finished, a flashing zero is displayed.
•Delayed start, programmed using the special button.
The selected delay is shown in the display and is updated every hour.
•Incorrect option selection. If an option which is not compatible with the set wash programme is selected, the message Err is displayed.
•Alarm code indicating a fault in the machine operation (see pages 31...34).
Programme progress display
By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on.
After the machine has started, only the running phase pilot light stays on. When the programme has finished, the END pilot light comes on.
If the CLEAN FILTER light flashes at the end of the pro- gramme this means that the drain filter is clogged.
The END pilot light flashes in the event of operating prob-
lems. At the same time one of the following lights starts to flash: RINSE HOLD = the machine does not fill
RINSE | = the machine does not empty |
WASH | = the door has not been closed |
To eliminate the problem, see the “Something not working” section.
15