If it is not possible to use one solid piece,
due to the additional 40 mm height required, ensure
that any additional strips of timber are
5 mm Hardwood strip
Additional pieces of 
timber should run
from front to back
glued and screwed to the underside of the base (see Fig. F).
Drill four fixing holes see Position the base into
the recess with its front edge as far forward as the adjoining plinth line will allow. The rea- son for placing the base in this position is to allow a small strip of beading to be fit- ted in front of the appliance feet.
Front
view
490 mm |
95 mm |
50 mm | Front edge | |
Top | ||
| ||
G | view |
Fix the base firmly to the floor using four appropriate countersunk screws
(see Fig. H).
With the appliance | Hardwood strip |
| |
installed adjust all four | 5 X 25 X 605 | ||
5 mm x 25 mm | |||
490 |
feet ensuring the machine | ||
is stable, and a clearance | ||
H | ||
of approximately 5 mm is | ||
|
left between the top of the machine and the underside of the work- top.
A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine adjust- ment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will provide additional security.
If required an additional door magnet, part number
51