User's instructions
Symptoms | Solutions | |
The machine leaks or overflows. | Check that: | |
| - there is too much detergent, | |
| - the detergent is suitable for machine washing, | |
| - the end of the drain hose is correctly secured, | |
| - the drain filter is properly replaced after cleaning, | |
| - the water inlet hose is not leaking. | |
The washing results are not satis- | Check that: | |
factory. | - the detergent is suitable for machine washing, | |
| - the machine is not overloaded, | |
| - the wash programme is suitable. | |
The machine vibrates or is very noisy. | Check that: | |
| - the transit bolts have been removed (see p. 34), | |
| - the appliance is level and installed correctly, | |
| - the appliance is not too close to a wall or other | |
| furniture, | |
| - the laundry is correctly distributed in the drum, | |
| - the appliance is not overloaded. | |
The lid does not open. | - The appliance is perhaps in the heating phase. | |
| - The lid is still locked. | |
The wash cycle is much too long. | Check that: | |
| - the water pressure is suficient, | |
| - the water inlet filter is not blocked, | |
| - there is not a water cut. | |
The machine stops during a wash | Check that: | |
cycle. | - the water pressure is sufficient, | |
| - the water inlet filter is not blocked, | |
| - the fuses are in good condition and have not blown, | |
| - the appliance is not finishing its wash programme | |
| by a rinse hold. | |
The laundry is not spun sufficiently | Check that: | |
or water remains in the drum. | - the drain hose is not kinked, | |
| - the height of the end of the drain hose is not higher | |
The END light flashes twice and an | than one metre, | |
- the drain pump filter is not blocked. | ||
acoustic signal is emitted twice*. | ||
| ||
Softener flows out of the overflow | Check that: | |
hole. | - you have used the correct amount, | |
| - the siphons on the rear of the detergent dispenser | |
| are not blocked. | |
|
|
* Depending on the model, some acoustic signals may appear.
30