User's instructions
Changing the spin speed
The spin speed can still be changed or the RINSE HOLD position "
" set, while the programme is running.
1.Press the START/PAUSE pushbutton "
".
2.Change the spin speed with the Spin Speed/RINSE HOLD pushbutton.
3.Press the START/PAUSE pushbutton "
" again. The washing programme continues.
Washing cycle complete/removing the washing
Once a washing programme cycle ended, the END light "
" illuminates on the Programme Progress Display.
If RINSE HOLD position "
" was selected, the indicator lights beside the DOOR " 
" and END "
" lights illuminate.
1. After a Rinse Hold, the water must first be drained:
–Either turn the programme selector to the OFF position "
", then turn it to the DRAIN programme "
" and press the START/PAUSE pushbutton
"
" (the water is drained without spinning), or
–turn the programme selector to the OFF position "
", then turn it to the
SPIN programme and press the START/PAUSE pusbutton "
" (the water is drained and the washing given a spin. The spin speed can also be changed during the spin cycle).
When this stage of the programme is completed, the END light "
" illuminates.
2. Open the door.
The door can be opened after the DOOR light " 
" goes off and the END light "
" has come on.
3.Remove the washing.
4.Turn the programme selector to the OFF position "
".
5.Close the water tap.
6.Leave the drum and the lid open to air the washing machine.
Important! If the washing machine is not to be used for a long period, close the water tap and disconnect the washing machine from the electricity mains.
24