Whirlpool LG9806XP manual Turn, Power on Selector, To check the load, Normal DRY

Page 4

I

Turn

2.

Touch FABRIC-TEMP

. power on

Selector

Move the POWER SWITCH up. You will have 8 seconds to touch a FABRIC-TEMP Selector.

Within 8 seconds, touch the lower part of a FABRIC-TEMP Selector. The dryer will not operate if you touch the upper half of the selector.

You may change the dryer setting at any time dunng any cycle by touching the desired selector or selectors.

Touch a CUSTOM DRY

3.or TIMED DRY Control

l To stop the dryer

1. Open the door, or...

2. Move POWER SWITCH to OFF.

IMPORTANT: If you do not touch a CUSTOM DRY or TIMED DRY Control,

the dryer will automatically select

NORMAL DRY.

If this is not the dryness you.like, you must touch one of the other dryness Controls. See page 6 of this book for more details.

l To check the load

1.Open door.

2.The dryer will remember where it was in the cycle it you restart the dryer within 2 minutes. Touch selector with the blinking light to restart.

4

Image 4
Contents Automatic Dryers Contents For Your Safety l Your ResponsibilitiesPower on Selector TurnTouch a Custom DRY Or Timed DRY Control To stop the dryer To check the loadMediumweight Cottons Type of Load Cottons LinensPermanent PRESS, Synthetics and Blends KnitsOperating instructions TheCUSTOM DRY ControlsCool down times Timed DRY ControlAIR Setting TL’MBLE Press Setting Finish GUARDControlEnd-of-cycle signal ? \’ Lint signalDrying times Mixed loads PERM’T Presvmed Using the drying rackFluff AIR Lint removal Lint screenElectric Dryers Cleaning Dryer Interior Vacation careChanging the drum light Before calling for Assistance.. ’ If you need AssistanceIf you need service If you have a problemPage 01985 Whirlpool Corporation