Important information

To ensure that the condenser dryer functions EN efficiently, the following routine maintenance

procedures must be carried out:

Fluff filter – CLEAN off any fluff build-up on the filter after each drying cycle.

Step 1

Open the dryer door by pressing it as shown in the picture.

Step 2

Pull out the filter (using two fingers).

Step 3

Clean off any fluff build-up on the internal surface of the filter.

Step 4

Replace the filter – never operate the dryer without the filter in place.

Failure to clean the filter after each drying cycle can undermine drying performance as the machine takes longer to dry and thus consumes more energy.

Water container – empty the water container after each drying cycle.

Step 1

Pull the water container towards you and remove it completely from the dryer.

Step 2

Empty all the water in the water container.

Step 3

Replace the water container making sure that it is securely fixed.

Failure to empty the water container may cause the following:

-The dryer stops heating (thus the load may still be damp at the end of the drying cycle).

-The “Empty water container” LED activates to show that the water container is full.

Filling of the Water Container

When the dryer is first used water will not immediately enter the water container as the pump needs to be primed. This is done automatically and will take a few minutes, during this period the efficiency of the drying process is not affected.