Indesit IDCE 8450 B K Sun icon Drying cycle Fan icon Cool air cycle, See Indicator lights

Page 6

ON/OFF/Reset button

EN Pressing the button normally will cause the machine to switch on or off. If the button is pressed for 3 seconds while the dryer is in use, the machine will switch off and the running cycle will reset.

Programme selection knob

Allows for setting the programme: turn until the indicator points towards the desired programme (see Starting and selecting a programme).

Options buttons

Allows selection of the options available for the selected programme. The respective indicator lights turn on when the option has been selected (see Programmes and options).

START/PAUSE button and indicator light

When the green light flashes slowly, press the button to start the programme. When the cycle is under way, the indicator light re- mains on. Press the button again to put the programme in the pause mode; the indicator light turns orange and starts flashing again. Press the button again to resume the programme from the point it was interrupted (see Starting and selecting a programme).

Display

In section A, the selected “Timed drying” value is displayed; if the “Delay start” function was set, the time remaining to the start of the selected programme will appear.

The duration of the selected programme is also displayed in this section. In section B, the phase of the running programme is displayed:

Sun icon : Drying cycle

Fan icon : COOL air cycle

In section C, the maintenance indicator lights are displayed (Empty water container indicator light

, Clean filter indicator light

,

Clean condenser unit indicator light)

, see Indicator lights.

 

 

CB

A

Indicator lights

The indicator lights provide important information. They indicate the following:

The “Empty water container” indicator light signals that the water container must be emptied.

If the water container fills during the course of the programme, the LED lights up. The dryer automatically starts a cool air cycle and the START/PAUSE LED flashes orange. Press the START/PAUSE button to resume the cycle from the point it was interrupted.

In order to avoid this procedure, always empty the water container after using the tumble dryer (see Maintenance).

Before each programme, the “Clean filter” indicator light signals the fundamental importance of cleaning the filter before each load (see Maintenance).

The “Clean condenser unit” indicator light signals the fundamental importance of cleaning the condenser regularly (see Maintenance).

6

Image 6
Contents Tumble Dryer Important information Filling of the Water ContainerPage Ventilation InstallationWhere to install the tumble dryer Electrical connectionsFeatures Description of the tumble dryerControl panel See Indicator lights Sun icon Drying cycle Fan icon Cool air cycleHow to carry out a drying cycle Starting and selecting a programmeProgramme chart Programmes and optionsSpecial/Sport/Partial Programmes Page Options Opening the doorLaundry Sorting laundryCare labels Special garments Drying timesAutomatic drying times Suggestions Save energy and respect the environmentCare and maintenance Door has not been closed properly TroubleshootingProblem Possible causes / Solutions Dryer is overloaded see LaundryInformation on recycling and disposal AssistanceSpare parts Comparative programmesGuarantee Months Parts and Labour GuaranteeEngineer to call ManufacturerPage 195104929.00