Indesit GB Washing Machine manual First wash cycle, Technical details

Page 3

Connecting the drain hose

GB

65 - 100 cm

Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor;

￿Do not use extensions or multiple sockets.

￿The power supply cable must never be bent or dangerously compressed.

￿The power supply cable must only be replaced by an authorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.

Installation Description

alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

￿We advise against the use of hose extensions; in case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electric connection

Before plugging the appliance into the mains socket, make sure that:

the socket is earthed and in compliance with the applicable law;

the socket is able to sustain the appliance's maximum power load indicated in the Technical details table (on the right);

the supply voltage is included within the values i ndicated on the Technical details table

(on the right);

the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug.

￿The washing machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

￿When the washing machine is installed, the mains socket must be within easy reach.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, setting the 90°C programme without a pre-wash cycle.

Technical details

Model

W IXE 127

 

 

 

59.5 cm wide

Dimensions

85 cm high

 

56.5 cm deep

 

 

Capacity

from 1 to 6 kg

 

 

Electric

voltage 230/240 Volts 50 Hz

connections

maximum absorbed power 1850 W

 

 

Water

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

connections

drum capacity 52 litres

 

 

 

Spin speed

up to 1200 rpm

 

 

Control

 

programmes

programme 2; temperature 60°C;

according to

run with a load of 6 kg.

IEC456 directive

 

This appliance is compliant with the following European Community Directives:

-73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments

-89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and

subsequent amendments - 2002/96/CE

Programmes Detergents Precautions

Care Troubleshooting Service

3

Image 3
Contents Washing Machine Instructions for useInstallation Unpacking and levellingElectric and water connections Technical details First wash cycleControl panel Washing machine descriptionMemo Programme DisplayStarting and Programmes Briefly starting a programmeProgramme table Personalisations Setting the spin cycleSetting the Delay Timer Setting the temperatureBleach cycle Detergents and laundryDetergent dispenser Preparing your laundrySaving energy and respecting the environment Precautions and adviceGeneral safety DisposalCare and maintenance Troubleshooting ProblemPossible causes/Solution 195053270.00 Service