Installing the CS 1226T System — Single Installer
If a single installer is installing the CS 1226T system, follow this procedure for the entire system:
NOTE: The ceiling grid must be installed before the installation of the CS 1226T begins.
• Verify if fiberglass ceiling tiles are being used (see step 2 below and step 11 on
page 7 for details).
• The grid face must be at least 15/16 inch (24 mm) for proper installation of the CS 120P (see step 20 on page 13 for details on suspending the enclosure on a smaller grid face).
Side View
15/16" (24 mm)
Grid Face
Figure 2. Grid Face Example
1.Disconnect power — Power down all attached devices before proceeding.
2.Verify the space where the system will be installed
3.Cut a hole for the CS 26T speaker — Use the provided cutout template to outline the hole to be cut in the ceiling tile as described below.
a.Remove the ceiling tile.
b.To find the center of the tile, use a tape measure to measure the space between two opposite corners, and mark the
c.Position the center hole of the cutout template directly over the center of the tile that you marked in step 3b.
d.Using the provided cutout template, trace a circle on the ceiling tile as follows:
For installations in ceiling tiles that are NOT fiberglass or when installing the speakers in an open back configuration: Trace a circle around the CS 26T cutout template.
NOTE: The fiberglass tile adapters are not needed and can be discarded.
For installations in
NOTE: A set of fiberglass tile adapters is provided with both the CS 26T and |
the CS 120P. Only one set is needed to install the CS 26T with the CS 120P |
kit in a |
i.Place the fiberglass tile adapter around the outer diameter of the template that was positioned in step 3c.
ii.Trace a circle around the outer diameter of the adapter.
CS 26T and CS 120P User Guide • Installation | 4 |