Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 120P Route the cables through the cover plate, Using a flexible conduit

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 12

8.Route the cables through the cover plate —

Flexible Conduit Adapter

Flexible Conduit

Cover Plate

Seismic Cable Pass

Through Loop

Rear of Speaker

Figure 6. Routing the Cables through the Cover Plate Using a Flexible Conduit

Using speaker wires without a conduit:

a. Secure the cable clamp adapter (included) to the cover plate.

b. Insert the wires through the clamp and cover plate, as shown in figure 7. c. Tighten the clamp screws.

Cable Clamp Adapter

Cover Plate

Seismic Cable Pass

Through Loop

Rear of Speaker

Figure 7. Routing the Cables Without a Conduit

CS 26T and CS 120P User Guide • Installation

8.Route the cables through the cover plate —

NOTES:

• The CS 120P is fully UL 2043 compliant only when it is used with a metal conduit or with plenum rated cables.

• Installation of all conduits, conduit adapters, wiring, and electrical connections must conform to all applicable building codes and local ordinances.

Using a flexible conduit:

a.Route wires through the conduit.

b.Insert the conduit into the cover plate opening using an appropriate conduit adapter, and secure the conduit to the plate as shown in figure 6.

c.Pull the wires out of the conduit and through the cover plate.

6

Image 12

Extron electronic CS 120P, CS 26T, CS 1226T manual Route the cables through the cover plate, Using a flexible conduit

Contents

CS 26T and CS 120P User GuideSpeakers CS 1226T SpeedMount Ceiling Speaker SystemSafety Instructions Safety Instructions EnglishChinese Simplified（简体中文） Instructions de sécurité FrançaisFCC Class A Notice Guide” on the Extron websiteCopyright TrademarksSpecifications Availability Conventions Used in this GuideNotifications Contents CS 26T and CS 120P User Guide Contents Features About this Guide Overview FeaturesIntroduction About this GuideApplication Example Extron CS 1226TInstallation Installation ConsiderationsInstallation Configurations Installation ConsiderationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit Using a flexible conduit 8.Route the cables through the cover plateedges Figure 11. Configuring the Bass Reflex Port Plate Number of Wires per Connection Point Maximum Wire GaugeFigure 12. Wiring a Single Speaker Figure 13. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through Red Wire + from Ampliﬁer Black Wire -from Ampliﬁer2 by 4 Ceiling Tile 4 Pole Connector Ampliﬁer19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 22. Adjusting the Rotary Tap Selector Figure 23. Installing the Speaker GrilleFigure 24. Grid Face Example Figure 26. Removing the Cover Plate Using a flexible conduit Using speaker wires without a conduit7.Route the cables through the cover plate Figure 28. Routing the Cables Without a Conduitedges Figure 32. Attaching Secondary Support Lines CS 120P Number of Wires per Maximum WireFigure 33. Wiring a Single Speaker Figure 34. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 42. Adjusting the Rotary Tap Selector Figure 43. Installing the Speaker GrilleInstalling the CS 120P in a Hard Ceiling Extron Warranty