Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 26T, CS 120P, CS 1226T manual Attaching Secondary Support Lines

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 19

Figure 21. Attaching Secondary Support Lines

20.Attach secondary support lines — If required, attach all of the secondary support lines as shown in figure 21.

ATTENTION: Do not allow any slack in the support cables.

NOTE: If the CS 26T will be installed in the CS 120P, do not attach secondary

support cables to the speakers.

Anchor ends to suitable solid secure points within the permanent building structure.

Secondary Support

Cables (3)

Secondary Support

Cable

	Attach cables here
	and secure.
Open Back	SC 26T with PRE 120

Figure 21. Attaching Secondary Support Lines

NOTES:

• When placing the CS 120P on a tile grid with a grid face less than 15/16 inch (24 mm) and no ceiling tile is installed, use the secondary attachment points as hanger suspension points.

• Observe all applicable building codes and local ordinances when installing the speaker.

21.Replace the adjacent tile — Reinstall the adjacent tile that was removed in step 4.

CS 26T and CS 120P User Guide • Installation 13

Image 19

Extron electronic CS 26T, CS 120P, CS 1226T manual Attaching Secondary Support Lines

Contents

CS 1226T SpeedMount Ceiling Speaker System CS 26T and CS 120PUser Guide SpeakersInstructions de sécurité Français Safety InstructionsSafety Instructions English Chinese Simplified（简体中文）Trademarks FCC Class A NoticeGuide” on the Extron website CopyrightConventions Used in this Guide Specifications AvailabilityNotifications Contents CS 26T and CS 120P User Guide Contents About this Guide FeaturesAbout this Guide Overview Features IntroductionExtron CS 1226T Application ExampleInstallation Considerations InstallationInstallation Considerations Installation ConfigurationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit 8.Route the cables through the cover plate Using a flexible conduitedges Figure 11. Configuring the Bass Reflex Port Plate Figure 13. Wiring Multiple Speakers in Parallel Number of Wires per Connection PointMaximum Wire Gauge Figure 12. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Ampliﬁer Red Wire + from AmpliﬁerBlack Wire -from Ampliﬁer 2 by 4 Ceiling Tile 4 Pole Connector19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 23. Installing the Speaker Grille Figure 22. Adjusting the Rotary Tap SelectorFigure 24. Grid Face Example Figure 26. Removing the Cover Plate Figure 28. Routing the Cables Without a Conduit Using a flexible conduitUsing speaker wires without a conduit 7.Route the cables through the cover plateedges Figure 32. Attaching Secondary Support Lines CS 120P Figure 34. Wiring Multiple Speakers in Parallel Number of Wires perMaximum Wire Figure 33. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 43. Installing the Speaker Grille Figure 42. Adjusting the Rotary Tap SelectorInstalling the CS 120P in a Hard Ceiling Extron Warranty