Extron electronic CS 120P, CS 26T Installation Considerations, Installation Configurations

Installation

This section provides instructions for installing the CS 26T speakers and the CS 120P enclosure. Topics include:

•Installation Considerations

•Installation Configurations

•Installing the CS 1226T — Single Installer

•Installing the CS 120P in a Suspended Ceiling — Division of Labor

•Installing the CS 26T in a Suspended Ceiling — Division of Labor

•Installing CS 120P in a Hard Ceiling

Installation Considerations

WARNING: Risk of severe bodily injury from falling or sharp equipment.

Installation and service must be performed by authorized personnel only.

•All wiring and electrical connections must conform to all applicable building codes and local ordinances.

•Installation in a plenum-rated environment requires plenum rated cable or conduit.

•If using secondary support cables, the installer provides the cables.

Installation Configurations

The CS 26T can be configured in the following ways:

•Open-back:For configurations in which the CS 120P is not used, use the C-ring accessory, available at www.extron.com. The C-ring spreads out the clamping force of the dog-legs when used in drop ceilings and gypsum ceilings.

•Using the CS 120P: When used with the CS 120P, the CS 26T can be placed in plenum environments. This is the only configuration that is UL 2043 rated.

NOTE: The CS 120P can be ordered separately or as part of the CS 1226T kit.

For hard ceiling installations, see Installing the CS 120P in a Hard Ceiling on page 26.

CS 26T and CS 120P User Guide • Installation 3