Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 1226T Route the cables through the cover plate, Using a flexible conduit

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 23

7.Route the cables through the cover plate —

7.Route the cables through the cover plate —

NOTES:

• The CS 120P is fully UL 2043 compliant only when it is used with a metal conduit or with plenum rated cables.

• Installation of all conduits, conduit adapters, wiring, and electrical connections must conform to all applicable building codes and local ordinances.

Using a flexible conduit:

a.Route wires through the conduit.

b.Insert the conduit into the cover plate opening using an appropriate conduit adapter, and secure the conduit to the plate as shown in figure 27.

c.Pull the wires out of the conduit and through the cover plate.

Flexible Conduit Adapter

Flexible Conduit

Cover Plate

Seismic Cable Pass

Through Loop

Rear of Speaker

Figure 27. Routing the Cables through the Cover Plate Using a Flexible Conduit

Using speaker wires without a conduit:

a.Secure the cable clamp adapter (included) to the cover plate.

b.Insert the wires through the clamp and cover plate, as shown in figure 28.

c.Tighten the clamp screws.

Cable Clamp Adapter

Cover Plate

Seismic Cable Pass

Through Loop

Rear of Speaker

Figure 28. Routing the Cables Without a Conduit

CS 26T and CS 120P User Guide • Installation 17

Image 23

Extron electronic CS 1226T, CS 120P, CS 26T manual Route the cables through the cover plate, Using a flexible conduit

Contents

CS 1226T SpeedMount Ceiling Speaker System CS 26T and CS 120PUser Guide SpeakersInstructions de sécurité Français Safety InstructionsSafety Instructions English Chinese Simplified（简体中文）Trademarks FCC Class A NoticeGuide” on the Extron website CopyrightNotifications Specifications AvailabilityConventions Used in this Guide Contents CS 26T and CS 120P User Guide Contents About this Guide FeaturesAbout this Guide Overview Features IntroductionExtron CS 1226T Application ExampleInstallation Considerations InstallationInstallation Considerations Installation ConfigurationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit 8.Route the cables through the cover plate Using a flexible conduitedges Figure 11. Configuring the Bass Reflex Port Plate Figure 13. Wiring Multiple Speakers in Parallel Number of Wires per Connection PointMaximum Wire Gauge Figure 12. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Ampliﬁer Red Wire + from AmpliﬁerBlack Wire -from Ampliﬁer 2 by 4 Ceiling Tile 4 Pole Connector19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 23. Installing the Speaker Grille Figure 22. Adjusting the Rotary Tap SelectorFigure 24. Grid Face Example Figure 26. Removing the Cover Plate Figure 28. Routing the Cables Without a Conduit Using a flexible conduitUsing speaker wires without a conduit 7.Route the cables through the cover plateedges Figure 32. Attaching Secondary Support Lines CS 120P Figure 34. Wiring Multiple Speakers in Parallel Number of Wires perMaximum Wire Figure 33. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 43. Installing the Speaker Grille Figure 42. Adjusting the Rotary Tap SelectorInstalling the CS 120P in a Hard Ceiling Extron Warranty