Extron electronic CS 26T, CS 120P, CS 1226T manual Attaching Secondary Support Lines

11.Place the CS 120P into the ceiling grid —­ Place the CS 120P over the tile grid so that the CS 120P is safely supported on the two short edges. If the ceiling tile was installed, ensure that the hole in the tile is aligned with the hole in the CS 120P (see figure 31).

NOTE: 2' x 2' (600 mm x 600 mm) grid mounting is the same as 2' x 4' (600 mm x 1200 mm) grid mounting.

Figure 31. Mounting the CS 120P in a 2' x 2' (600 mm x 600 mm) Ceiling Grid

12.Attach secondary support lines —­ If required, attach all of the secondary support lines as shown in figure 32.

ATTENTION: Do not allow any slack in the support cables.

NOTE: If the CS 26T will be installed in the CS 120P, do not attach secondary

support cables to the speakers.

Anchor ends to suitable solid secure points within the permanent building structure.

Secondary Support

Cables (3)

Attach cables here and secure.

SC 26T with PRE 120

Figure 32. Attaching Secondary Support Lines

NOTE:

• When placing the CS 120P on a tile grid with a grid face of less than 15/16 inch (24 mm) and no ceiling tile is installed, use the secondary attachment points as hanger suspension points.

• Observe all applicable building codes and local ordinances when installing the speaker.

13.Replace the adjacent tile — Reinstall the adjacent tile if one was removed in step 5.

CS 26T and CS 120P User Guide • Installation 19