Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 120P, CS 1226T manual Mount the CS 26T see figure

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 30

8.Mount the CS 26T (see figure 41).

7.Attach the speaker wire to the strain relief tie down point using the provided zip tie.

	Strain Relief Tab	Captive Screw
		Connector
	(zip tie)

Figure 40. Attaching the Speaker Wire to the Strain Relief Point

8.Mount the CS 26T (see figure 41).

a.Insert the CS 26T through the bottom of the hole in the ceiling tile that was cut in step 2.

b.Tighten the four screws (clockwise) until the speaker is securely clamped to the ceiling.

Figure 41. Mounting the Speaker to the CS 120P

ATTENTION: Do not overtighten the screws.

CS 26T and CS 120P User Guide • Installation 24

Image 30

Extron electronic CS 120P, CS 1226T manual Mount the CS 26T see figure

Contents

Speakers CS 26T and CS 120PUser Guide CS 1226T SpeedMount Ceiling Speaker SystemChinese Simplified（简体中文） Safety InstructionsSafety Instructions English Instructions de sécurité FrançaisCopyright FCC Class A NoticeGuide” on the Extron website TrademarksSpecifications Availability Conventions Used in this GuideNotifications Contents CS 26T and CS 120P User Guide Contents Introduction FeaturesAbout this Guide Overview Features About this GuideApplication Example Extron CS 1226TInstallation Configurations InstallationInstallation Considerations Installation ConsiderationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit Using a flexible conduit 8.Route the cables through the cover plateedges Figure 11. Configuring the Bass Reflex Port Plate Figure 12. Wiring a Single Speaker Number of Wires per Connection PointMaximum Wire Gauge Figure 13. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through 2 by 4 Ceiling Tile 4 Pole Connector Red Wire + from AmpliﬁerBlack Wire -from Ampliﬁer Ampliﬁer19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 22. Adjusting the Rotary Tap Selector Figure 23. Installing the Speaker GrilleFigure 24. Grid Face Example Figure 26. Removing the Cover Plate 7.Route the cables through the cover plate Using a flexible conduitUsing speaker wires without a conduit Figure 28. Routing the Cables Without a Conduitedges Figure 32. Attaching Secondary Support Lines CS 120P Figure 33. Wiring a Single Speaker Number of Wires perMaximum Wire Figure 34. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 42. Adjusting the Rotary Tap Selector Figure 43. Installing the Speaker GrilleInstalling the CS 120P in a Hard Ceiling Extron Warranty