Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 26T manual Adjusting the Rotary Tap Selector, Installing the Speaker Grille

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 31

Figure 42. Adjusting the Rotary Tap Selector

9.Set the rotary tap selector switch — Use a small screwdriver to set the tap selector switch to the appropriate setting.

ATTENTION: When setting the taps for a distributed (high impedance) system, do not tap the system above the rated power of the amplifier. When connecting multiple speakers in 8-ohm mode, be sure that the combined rated impedance does not equal a value less than the minimum rated impedance of the amplifier.

100 V

2W	8Ω	16W
4W		8W
8W		4W
16W		2W
	8Ω	1W

V 70

Adjust the Tap Selector

Figure 42. Adjusting the Rotary Tap Selector

10.Install the grille — Position the outer perimeter of the grille into the groove of the speaker baffle. Six magnets pull the grille securely into place.

Speaker Grille

Figure 43. Installing the Speaker Grille

NOTE: Grille hooks are provided for removal of the grille after installation.

CS 26T and CS 120P User Guide • Installation 25

Image 31

Extron electronic CS 26T, CS 120P, CS 1226T manual Adjusting the Rotary Tap Selector, Installing the Speaker Grille

Contents

CS 1226T SpeedMount Ceiling Speaker System CS 26T and CS 120PUser Guide SpeakersInstructions de sécurité Français Safety InstructionsSafety Instructions English Chinese Simplified（简体中文）Trademarks FCC Class A NoticeGuide” on the Extron website CopyrightConventions Used in this Guide Specifications AvailabilityNotifications Contents CS 26T and CS 120P User Guide Contents About this Guide FeaturesAbout this Guide Overview Features IntroductionExtron CS 1226T Application ExampleInstallation Considerations InstallationInstallation Considerations Installation ConfigurationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit 8.Route the cables through the cover plate Using a flexible conduitedges Figure 11. Configuring the Bass Reflex Port Plate Figure 13. Wiring Multiple Speakers in Parallel Number of Wires per Connection PointMaximum Wire Gauge Figure 12. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Ampliﬁer Red Wire + from AmpliﬁerBlack Wire -from Ampliﬁer 2 by 4 Ceiling Tile 4 Pole Connector19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 23. Installing the Speaker Grille Figure 22. Adjusting the Rotary Tap SelectorFigure 24. Grid Face Example Figure 26. Removing the Cover Plate Figure 28. Routing the Cables Without a Conduit Using a flexible conduitUsing speaker wires without a conduit 7.Route the cables through the cover plateedges Figure 32. Attaching Secondary Support Lines CS 120P Figure 34. Wiring Multiple Speakers in Parallel Number of Wires perMaximum Wire Figure 33. Wiring a Single SpeakerWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 43. Installing the Speaker Grille Figure 42. Adjusting the Rotary Tap SelectorInstalling the CS 120P in a Hard Ceiling Extron Warranty