Manuals / Extron electronic / Home Audio / Speaker

Extron electronic CS 1226T manual Adjusting the Rotary Tap Selector, Installing the Speaker Grille

Models: CS 1226T CS 26T CS 120P

1 33

Download 33 pages 50.04 Kb

Page 20

Figure 22. Adjusting the Rotary Tap Selector

22.Set the rotary tap selector switch — Use a small screwdriver to set the tap selector switch to the appropriate setting.

ATTENTION: When setting the taps for a distributed (high impedance) system, do not tap the system above the rated power of the amplifier. When connecting multiple speakers in 8-ohm mode, be sure that the combined rated impedance does not equal a value less than the minimum rated impedance of the amplifier.

100 V

2W	8Ω	16W
4W		8W
8W		4W
16W		2W
	8Ω	1W

V 70

Adjust the Tap Selector

Figure 22. Adjusting the Rotary Tap Selector

23.Install the grille. Position the outer perimeter of the grille into the groove of the speaker baffle. Six magnets pull the grille securely into place.

Speaker Grille

Figure 23. Installing the Speaker Grille

NOTE: Grille hooks are provided for removal of the grille after installation.

CS 26T and CS 120P User Guide • Installation 14

Image 20

Extron electronic CS 1226T, CS 120P, CS 26T manual Adjusting the Rotary Tap Selector, Installing the Speaker Grille

Contents

CS 26T and CS 120P User GuideSpeakers CS 1226T SpeedMount Ceiling Speaker SystemSafety Instructions Safety Instructions EnglishChinese Simplified（简体中文） Instructions de sécurité FrançaisFCC Class A Notice Guide” on the Extron websiteCopyright TrademarksNotifications Specifications AvailabilityConventions Used in this Guide Contents CS 26T and CS 120P User Guide Contents Features About this Guide Overview FeaturesIntroduction About this GuideApplication Example Extron CS 1226TInstallation Installation ConsiderationsInstallation Configurations Installation ConsiderationsInstalling the CS 1226T System - Single Installer Figure 3. Install the Ceiling Mount Kit Using a flexible conduit 8.Route the cables through the cover plateedges Figure 11. Configuring the Bass Reflex Port Plate Number of Wires per Connection Point Maximum Wire GaugeFigure 12. Wiring a Single Speaker Figure 13. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through Red Wire + from Ampliﬁer Black Wire -from Ampliﬁer2 by 4 Ceiling Tile 4 Pole Connector Ampliﬁer19.Mount the CS 26T see figure Figure 21. Attaching Secondary Support Lines Figure 22. Adjusting the Rotary Tap Selector Figure 23. Installing the Speaker GrilleFigure 24. Grid Face Example Figure 26. Removing the Cover Plate Using a flexible conduit Using speaker wires without a conduit7.Route the cables through the cover plate Figure 28. Routing the Cables Without a Conduitedges Figure 32. Attaching Secondary Support Lines CS 120P Number of Wires per Maximum WireFigure 33. Wiring a Single Speaker Figure 34. Wiring Multiple Speakers in ParallelWiring Multiple Speakers Using Loop-through Figure 38. Impedance Test Points - Loop-throughConfiguration 8.Mount the CS 26T see figure Figure 42. Adjusting the Rotary Tap Selector Figure 43. Installing the Speaker GrilleInstalling the CS 120P in a Hard Ceiling Extron Warranty