Hotpoint Washing Machine manual

Page 14

GB

The machine is noisy.

The machine wont spin properly.

The machine leaks from the dispenser.

The machine leaks (other than dispenser).

There will always be some motor, pump and drum noise during spin.

Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

The dispenser drawer is blocked with detergent and requires cleaning.

The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again.

The machine is tilting forwards - It must be level when in its final position.

The fill hose is loose, check both the cabinet and tap ends.

The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer.

The drain hose is not fixed in properly.

The indicator lights on the console are flashing rapidly.

The machine smells.

The machine door cannot be opened.

Door Seal damaged at the bottom.

The water level is too low when the machine is washing.

There is too much foam.

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again If the problem persists contact the Technical Assistance Service.

The machine requires a service wash. Run a 60 degree wash cycle with deter- gent and no laundry.

The door will not open until the door lock indicator light goes out shortly after the program has finished.

The door seal has drainage holes at the bottom - This is normal.

The water level is correct if it can be seen at the bottom of the door.

The detergent is not suitable for machine washing (it should display the text ‘for washing machines’ or ‘hand and machine wash’ or the like).

Too much detergent was used - less detergent is required in soft water.

After completing the programme, or before starting a programme, the machine has turned itself off (no lights).

General.

To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected.

Your washing machine contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/pro- gress).

Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not have a wash label, or wash items that are not intended as machine washable.

14

Image 14
Contents Instructions for use Washing MachineElectric and water connections InstallationUnpacking and levelling 65 100 cm Bution board How to connect an alternative plugFirst wash cycle With the following codeTechnical data Description of the washing machine and starting a wash cycle ON/OFF buttonWash Rinse Spin Pump out Indicator lightsStarting a wash cycle Wash cycles Table of wash cyclesTemperature may be lowered, or even set to a cold wash Setting the temperatureSetting the spin speed PersonalisationPreparing the laundry Detergents and laundryDetergent dispenser drawer Garments requiring special careDisposal Precautions and tipsGeneral safety Opening the porthole door manuallyCleaning the pump Care and maintenanceCleaning the washing machine Cutting off the water and electricity GB suppliesTroubleshooting Problem Possible causes / SolutionsPage GuaranteeGB Assistance195100086.00 You must register your appliance with us

Washing Machine specifications

Hotpoint washing machines have earned a remarkable reputation for their reliability, innovative technologies, and user-friendly features. These appliances are designed to provide effective laundry solutions, ensuring that clothes are cleaned thoroughly while remaining gentle on fabrics. Let's explore the main features, technologies, and characteristics that set Hotpoint washing machines apart.

One of the most notable features of Hotpoint washing machines is their energy efficiency. Many models are equipped with an A+++ energy rating, which indicates low energy consumption. This not only helps in reducing energy bills but also contributes to a more sustainable approach to washing laundry. Hotpoint has made a commitment to environmental responsibility, designing machines that minimize water usage and energy consumption without compromising performance.

Another key technology found in Hotpoint washing machines is the Anti-Stain technology. This innovative feature effectively targets and eliminates a variety of tough stains by optimizing the washing cycle for different fabrics. The machine recognizes the type of stain and adjusts the temperature and wash action accordingly, ensuring that all garments are treated with care. This focus on stain removal is especially beneficial for families with children or those engaged in outdoor activities.

Hotpoint washing machines also incorporate the Direct Injection technology, which pre-mixes detergent and water before it enters the drum. This allows for better distribution of detergent throughout the wash cycle, leading to cleaner clothes and reduced detergent waste. By enhancing the efficiency of the wash process, this technology ensures that clothes come out sparkling clean with less effort.

In terms of user convenience, Hotpoint washing machines come equipped with intuitive touch controls and a selection of pre-programmed cycles tailored to various fabric types and washing needs. Models often feature quick wash cycles, allowing users to enjoy thoroughly cleaned clothes in a fraction of the time. Additionally, many Hotpoint machines offer a delay-start function, enabling users to schedule washes during off-peak energy times or when it’s most convenient for them.

The design and build quality of Hotpoint washing machines also deserve mention. With modern aesthetics and durable materials, these machines can seamlessly blend into any laundry room while ensuring reliability. Furthermore, many models come with a large drum capacity, accommodating larger loads and reducing the frequency of laundry days.

In summary, Hotpoint washing machines combine efficiency, innovative technologies, and user-friendly features to create a superior laundry experience. The blend of energy efficiency, stain removal capabilities, and advanced wash technologies makes them a popular choice among consumers looking for reliable and effective laundry solutions. With their commitment to quality and sustainability, Hotpoint continues to be a leader in the washing machine market.