Troubleshooting

Problem:

The display states “door”

The display shows F000

The laundry has not spun dry.

The time to end jumps.

The programme takes a long time.

I cannot read the information on the LCD Display.

Steam is coming from the dispenser drawer

There is too much foam?

The detergent dispenser will not close properly or is collecting water?

Not all the detergent has been flushed away?

Possible causes / Solution:

●The door is not fully closed, please close fully to start cycle.

●Where 000 is the number (please contact Hotpoint Service and quote the number).

●Did you select a short spin programme?

●Did you reduce the spin speed of the selected programme? (see Programmes and Option Modifiers).

●Estimated programme times are dependant on temperature and pressure of the incoming water supply, option(s) selected and the load being washed. They may therefore change during fill stages to take into account extra fill time or heating required.

●Check for low water pressure.

●Programme times listed in the Programme Table are approximate. Options selected can affect the programme times (see Programmes and Option Modifiers).

●If the display is not showing the correct information:

-Switch Off at the electric socket. Wait 5 seconds then switch back on.

●This is not a fault, we have designed the machine to release steam from the dispenser drawer during hot washes.

●The detergent is not suitable for machine washing:

If you have used the wrong type of detergent, select a Rinse programme to flush out your machine.

●You used too much detergent (see Detergent and Laundry): Refer to the manufacturer’s recommendations.

●Check the drawer is properly aligned.

●Clean the dispenser drawer (see Care and Maintenance).

●Check the cold water supply tap is turned on fully.

●Check the water inlet hose is not kinked.

●The water pressure is insufficient.

Explained	Wash Labels

Contents

Description

Option Modifiers	Programmes and

Troubleshooting

Advice	Safety

Details	Technical

Service