Whirlpool W10115226C, W10115227C-SP Remove bottom screws, Lift door off top screws

Page 19

Reverse Door Swing

4. Remove screws from hinges

(Models with side-swing doors with glass)

 

1. Place towel on dryer

 

Place towel on top of dryer to avoid damaging the surface.

2. Remove bottom screws

Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer cabinet side of hinges.

3. Lift door off top screws

Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from dryer cabinet.

Remove screws attaching hinges to door.

5. Flip door over

Flip door over so handle side is down.

6. Remove screws from door

Remove screws at top, bottom, and side of door (4 screws). Keep door screws separate from hinge screws as they are different sizes.

7. Separate inner from outer door

Holding door over towel on dryer, pry inner door and lift to separate it from outer door.

NOTE: Do not pull on door seal or plastic door catches.

19

Image 19
Contents Wide Models U.S.A. only Dryer Safety Tools and Parts Installation RequirementsLocation Requirements Electrical Requirements If your outlet looks like this If connecting by direct wireChoose a standard power supply cord connector Electrical ConnectionScrew in leveling legs Prepare dryer for leveling legs Install Leveling LegsRemove terminal block cover Power Supply Cord Direct WireElectrical Connection Choose electrical connection typeWire Power Supply Cord Connection Power Supply Cord ConnectionConnect remaining wires Connect ground wireConnect remaining wires Remove center screw Connect neutral wireAttach direct wire cable to strain relief Direct Wire ConnectionWire Direct Wire Connection Attach direct wire strain reliefPrepare your 3-wire cable for direct connection Connect external ground wire Optional 3-Wire ConnectionVenting Requirements VentingVenting Kits Optional exhaust installationsAlternate installations for close clearances Plan Vent SystemConnect Vent Install Vent SystemIf the dryer will not start, check the following Complete Installation ChecklistLevel Dryer Level DryerReverse Door Swing Optional Door ReversalInsert screws in hinge holes on dryer cabinet Flip door overAttach door hinges Remove and transfer plugsLift door off top screws Remove bottom screwsSeparate inner from outer door Remove door strike plug TroubleshootingRotate outer door Remove and transfer plugs Remove door strike