8. Rotate outer door | 11. Remove and transfer plugs |
Take outer door and rotate it 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. Insert 4 door screws.
9. Attach door hinges
Reattach door hinges to dryer door so that the larger hole is at the bottom of the hinge.
10. Remove door strike
Remove door strike from dryer cabinet and set aside.
Remove the 4 screws that attach 2 plugs on the left side. Transfer plugs to opposite side using the same 4 screws.
12. Insert screws in hinge holes on dryer cabinet
NOTE: 2 people may be needed to reinstall door.
Insert screws into the bottom holes on left side of dryer cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.
13. Remove door strike plug
Remove door strike plug. Insert the door strike removed in Step 10 into hole and secure with screw. Insert door strike plug into original door strike hole and secure with screw.
14. Check door strike alignment
Close door and check that door strike aligns with door catch. If it is needed, slide door catch left or right within slot to adjust alignment.
Troubleshooting
W10115226C
© 2012 Whirlpool Corporation
20All rights reserved
See the Use and Care Guide or visit our website and reference “Frequently Asked Questions” to possibly avoid the cost of a service call.