Whirlpool 8TCEM2760KQ0 installation instructions Maintenance instructions

Page 17

Maintenance instructions:

Clean lint screen after each cycle.

Removing accumulated lint:

From inside the dryer cabinet:

Lint should be removed every 2 years or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the exhaust vent:

Lint should be removed every 2 years, or more often, depending on dryer usage.

If dryer does not operate check the following:

Electric supply is connected.

Circuit breaker is not tripped or house fuse is not blown.

Door is closed.

Controls are set in a running or “ON” position.

START button has been pushed firmly.

For gas dryers, check that gas supply shutoff valves are set in open position.

If you need assistance:

The Commercial Laundry Support Center will answer any questions about operating or maintaining your dryer not covered in the Installation Instructions. The Commercial Laundry Support Center is open 24 hours a day, 7 days a week. Just dial

1-800 NO BELTS (1-800-662-3587) — the call is toll free.

When you call, you will need the dryer model number and serial number. Both numbers can be found on the serial-rating plate located in the dryer door well.

17

Image 17
Contents Installation Instructions Dryer Safety What to do if YOU Smell GAS Tools and Parts Recessed Area and Closet Installation InstructionsLocation Requirements Tools neededProduct Dimensions 29 73.7 cm dryer Product Dimensions 27 68.6 cm dryerRecommended Ground Method Electrical Requirements Gas DryerElectrical Requirements Electric Dryer Type of Gas Gas Supply RequirementsGas Supply Line Gas Supply Pressure TestingVenting Requirements Maximum Vent Length Vent System Length Multiple Dryer VentingConnect Vent Install Coin Slide and Coin BoxComplete Installation Make Electrical Connection Power Supply Cord Method U.S. OnlyPower Supply Cord, Four-wire electrical connection EDC Power Supply Cord, Three-wire electrical connectionDirect Wire Four-wire electrical connection Direct Wire Method U.S. OnlyLoosen or remove the center terminal block screw Direct Wire Three-wire electrical connectionChanging to a 30- or 60-MINUTE Timing CAM Maintenance instructions 2006 05/2006 W10103110 Page Page Page 35.6 cm 38.1 cm 27 68.6 cm 5 cm Page Page Page No. of 90 turns Page Page Page EDC ¹⁄₂ 8.9 cm 12.7 cm 2 8.9 cm Page Page W10103110