Whirlpool L-63 manual Potential Fire Hazard, Recessed and Closet Installation Instructions

Page 13

c.Door is closed.

d.Controls are set in running or “On” position.

e.Gas shut-off valve is open on supply lines.

Recessed and Closet Installation Instructions

!WARNING

Potential Fire Hazard

The dryer must be exhausted outside. If dryer is installed in a closet, the dryer MUST be exhausted outside. Failure to do so increases the risk of fire.

This dryer may be installed in a recessed area or closet. (Fig. 5)

The installation spacing is in inches and is the minimum allowable. Additional spacing should be considered for ease of installation, servicing and compliance with local codes and ordinances. If closet door is installed, the minimum of unobstructed air openings in top and bottom is required. Louvered doors with equivalent air openings are acceptable. Closet installation must be exhausted.

Only recessed installations with no cabinet or shelf above the dryer need not be exhausted. Non- exhausted recessed installations require an exhaust deflector.

Other installations must use the minimum dimensions indicated.

To prevent large amounts of lint and moisture from accumulating and to maintain drying efficiency, this appliance must be exhausted outdoors.

Note: No fuel burning appliance may be installed in the same closet as the dryer.

Fig. 5

8

Image 13
Contents Electric & GAS Dryers Introduction Table of Contents Section Four Page Electrical Requirements for Gas Dryers Electrical RequirementsElectrical Shock Hazard Recommended Grounding MethodElectrical Connection Electrical Requirements for Electric DryersGrounding Instructions Page Exhaust Requirements for Gas and Electric Dryers Fire Hazard Gas Requirements for Gas Dryers Page Potential Fire Hazard Recessed and Closet Installation InstructionsSection TWO Console Timer ControlElectronic Dry-Miser Timed Dry CyclePUSH-TO-START Knob Clean Touch Control PADVersion Electronic Dryer Control Fluff Air CycleHeated Air Circulation Side and Bottom Exhaust Venting Kit Console Control Repairs Section ThreeRemoving the Console Removing the Clean Touch Switch Assembly Removing the TimerRemoving the Push to Start Switch Removing the BuzzerReplacing the Drum Lamp Removing the Door SwitchRemoving the Toe Panel Replacing the Blower Wheel Removing Blower HousingReplacing the Operating Thermostat and Bias Heater Replacing the MotorReplacing the Thermal Fuse Replacing the Heat Duct Assembly Removing the Burner Assembly Gas DryersReplacing the Heating Element Electric Dryers Replacing the High Limit Thermostat and Thermal CutoffRemoving the Front Panel Removing the Dryer DoorRemoving the Belt and the Drum Replacing the Grille AssemblyReplacing the Front Support Rollers and Shafts Reattaching the Rear Bulkhead Removing the Rear Bulkhead AssemblyPage Section Four Troubleshooting GuideTimer Shuts Off but Clothes are Still Damp Component TestingTimer Does Not Advance but Clothes are Dry Section Five Wiring DiagramElectric Dryer Gas Dryer Strip Circuits Timer SchedulePage Page MODEL/SERIAL Number Designations MODEL/SERIAL Number Plate Location100003 Rprt