Whirlpool L-63 manual Removing the Dryer Door, Removing the Front Panel

Page 24

Removing the Dryer Door

1.Remove the toe panel.

2.Pull down and unhook and remove the left and right door springs. (Fig. 36)

3.Open dryer door. Remove the screws from each door hinge. (Fig. 37) Remove dryer door by sliding it off of hinges.

4.Slide new door onto hinges. Align screw holes in hinges. Reinstall hinge screws into new

dryer

door. Close dryer door.

5.Hook long, skinny end of door spring into left hinge. Pulling down on spring, hook other end into bottom front of cabinet. Repeat with other spring.

6.Snap toe panel into place.

Fig. 37

Fig. 36

Removing the Front Panel

1.

Remove the dryer top.

 

2.

Remove the toe panel.

 

3.

Remove the lint screen.

 

4.

Release the two (2) door springs.

 

5.

Remove the two screws attaching

 

 

the lint duct to the dryer and remove the lint duct.

 

6.

Remove the two (2) screws at the bottom and the

 

 

two (2) screws at the top of the front panel. (Fig. 38)

Fig. 38

7.Pull wiring harness out of clips inside top side of dryer. Disconnect the wiring harness. (Fig. 39)

8.Lift up and remove front panel. (Fig. 40)

Fig. 39

Fig. 40

19

Image 24
Contents Electric & GAS Dryers Introduction Table of Contents Section Four Page Electrical Requirements Electrical Requirements for Gas DryersElectrical Shock Hazard Recommended Grounding MethodElectrical Requirements for Electric Dryers Electrical ConnectionGrounding Instructions Page Exhaust Requirements for Gas and Electric Dryers Fire Hazard Gas Requirements for Gas Dryers Page Recessed and Closet Installation Instructions Potential Fire HazardConsole Timer Control Section TWOElectronic Dry-Miser Timed Dry CycleClean Touch Control PAD PUSH-TO-START KnobVersion Electronic Dryer Control Fluff Air CycleHeated Air Circulation Side and Bottom Exhaust Venting Kit Section Three Console Control RepairsRemoving the Console Removing the Timer Removing the Clean Touch Switch AssemblyRemoving the Push to Start Switch Removing the BuzzerRemoving the Door Switch Replacing the Drum LampRemoving the Toe Panel Removing Blower Housing Replacing the Blower WheelReplacing the Motor Replacing the Operating Thermostat and Bias HeaterReplacing the Thermal Fuse Removing the Burner Assembly Gas Dryers Replacing the Heat Duct AssemblyReplacing the Heating Element Electric Dryers Replacing the High Limit Thermostat and Thermal CutoffRemoving the Dryer Door Removing the Front PanelReplacing the Grille Assembly Removing the Belt and the DrumReplacing the Front Support Rollers and Shafts Removing the Rear Bulkhead Assembly Reattaching the Rear BulkheadPage Troubleshooting Guide Section FourComponent Testing Timer Shuts Off but Clothes are Still DampTimer Does Not Advance but Clothes are Dry Wiring Diagram Section FiveElectric Dryer Gas Dryer Timer Schedule Strip CircuitsPage Page MODEL/SERIAL Number Plate Location MODEL/SERIAL Number Designations100003 Rprt