Whirlpool GEW9200LQ0 manual Dryer USE, StartingYour Dryer, To use an Automatic Cycle

Page 18

DRYER USE

StartingYour Dryer

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Do not dry anything that has ever had anything flammable on it (even after washing).

Failure to follow these instructions can result in death, explosion, or fire.

Fire Hazard

No washer can completely remove oil.

Do not dry anything that has ever had any type of oil on it (including cooking oils).

Items containing foam, rubber, or plastic must be dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in death or fire.

WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.

The following is a guide to starting your dryer. Please refer to specific sections of this manual for more detailed information.

1.Clean lint screen before or after each cycle.

2.Place laundry into dryer and shut door. See “Loading.”

3.Rotate the dial to select either an Automatic or Manual Cycle then press the CONTROL ON button. The preset settings and drying time for the cycle chosen will be displayed.

To use an Automatic Cycle

Point the dial to an Automatic Cycle.

Select DRYNESS LEVEL to adjust how dry you want the load to be. The time displayed is an estimated length of the cycle based on the Dryness Level selected. As the cycle runs, the control senses the dryness of the load and adjusts the time automatically for the selected Dryness Level.

NOTE: Time is not adjustable for Automatic Cycles. Pressing the More Time or Less Time buttons will cause a triple beep, indicating that the time cannot be changed.

Press the WRINKLE SHIELD™ feature button if this option is desired.

Press the END OF CYCLE SIGNAL button to set signal volume to desired level.

Press (and hold) HOLD TO START button until dryer starts (about 1 second).

Once an Automatic cycle has started, the WRINKLE SHIELD™ feature and the End of Cycle Signal level can be adjusted. Press the PAUSE/CANCEL key twice to stop the dryer and clear the settings, allowing you to select another cycle and Dryness Level.

18

Image 18
Contents Electronic Electric Dryer Use & Care Guide3979274B Table of Contents Dryer Safety Your safety and the safety of others are very importantOptional Pedestal Installation InstructionsToolsandParts Parts neededCustom undercounter installation Dryer only Installation clearancesDryer Dimensions Location RequirementsMobile home installations require Minimum installation spacing for cabinet installationMobile home-additional installation requirements Closet installation Dryer onlyElectrical Requirements It is your responsibilityElectrical Connection ElectricalConnection Wire connection Power supply cord Wire connection Direct wire Optional 3-wire connection VentingRequirements Typical exhaust installationsOptional exhaust installations PlanVentSystemAlternate installations for close clearances Special provisions for mobile home installationsDetermine Vent Length Install VentSystem Install Leveling LegsLevel Dryer Loosen door trim Connect VentReverse Door Swing Remove the doorReinstalling the door Install new handle filler and hinge coverReverse the hinge and hinge bracket Complete Installation If the dryer will not start, check the followingDryer USE StartingYour DryerTo use an Automatic Cycle Stopping YourDryer Pausingor RestartingLoading Control LockedStatusLights CyclesAdditional Features End of Cycle Signal Drying RackCleaningthe Dryer Interior Cleaning theDryer LocationCleaning the Lint Screen Dryer CareTroubleshooting Vacation and Moving CareChangingthe Drum Light Lint on load Dryer will not runUnusual sounds Stains on load or color changeFor assistance and service Assistance or ServiceIf you need replacement parts Accessories U.S.APage Whirlpool Corporation will not pay for 3979274B