Whirlpool GEW9200LQ0 manual Troubleshooting, Vacation and Moving Care, Changingthe Drum Light

Page 24

Vacation and Moving Care

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Wash lint screen.

Moving care

1.Unplug dryer or disconnect power. Disconnect wiring if dryer is direct wired.

2.Make sure leveling legs are secure in dryer base.

3.Use masking tape to secure dryer door.

Changingthe Drum Light

The dryer light automatically turns on inside the dryer drum when you open the door.

To change the drum light

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Dryer displaying code message

“PF” (power failure), check the following:

Was the drying cycle interrupted by a power failure?

Press (and hold) HOLD TO START button to restart the dryer.

“E” Variable (E1, E2, E3) service codes: Call for service.

Clothes are not drying satisfactorily

Check the following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint, restricting air movement? Run the dryer for 5-10 minutes. Hold your hand under the outside exhaust hood to check air movement. If you do not feel air movement, clean exhaust system of lint or replace exhaust vent with heavy metal or flexible metal vent. (See “Installation Instructions.”)

Is the exhaust vent crushed or kinked? Replace with a heavy metal vent. (See “Installation Instructions.”)

Has a fuse blown, or a circuit breaker tripped? Electric dryers use 2 household fuses or breakers. The drum may be turning, but you may not have heat.

Has an air cycle been selected? Select the right cycle for the types of garments being dried (see “Cycles”).

Is the automatic cycle ending early? The load may not be contacting the electronic sensor strips, level the dryer.

Are fabric softener sheets blocking the grille? Use only one fabric softener sheet and only use it once.

Is the dryer located in a room with temperature below 45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above 45ºF (7ºC).

Was a cold rinse water used? Was the load very wet? Expect longer drying times with items rinsed in cold water and with items that hold moisture (cottons).

Is the load too large and heavy to dry quickly? Separate the load to tumble freely.

24

Image 24
Contents Electronic Electric Dryer Use & Care Guide3979274B Table of Contents Dryer Safety Your safety and the safety of others are very importantInstallation Instructions ToolsandPartsOptional Pedestal Parts neededInstallation clearances Dryer DimensionsCustom undercounter installation Dryer only Location RequirementsMinimum installation spacing for cabinet installation Mobile home-additional installation requirementsMobile home installations require Closet installation Dryer onlyElectrical Requirements It is your responsibilityElectrical Connection ElectricalConnection Wire connection Power supply cord Wire connection Direct wire Optional 3-wire connection Typical exhaust installations Optional exhaust installationsVentingRequirements PlanVentSystemAlternate installations for close clearances Special provisions for mobile home installationsDetermine Vent Length Install VentSystem Install Leveling LegsLevel Dryer Connect Vent Reverse Door SwingLoosen door trim Remove the doorReinstalling the door Install new handle filler and hinge coverReverse the hinge and hinge bracket Complete Installation If the dryer will not start, check the followingDryer USE StartingYour DryerTo use an Automatic Cycle Pausingor Restarting LoadingStopping YourDryer Control LockedStatusLights CyclesAdditional Features End of Cycle Signal Drying RackCleaning theDryer Location Cleaning the Lint ScreenCleaningthe Dryer Interior Dryer CareTroubleshooting Vacation and Moving CareChangingthe Drum Light Dryer will not run Unusual soundsLint on load Stains on load or color changeAssistance or Service If you need replacement partsFor assistance and service Accessories U.S.APage Whirlpool Corporation will not pay for 3979274B