Whirlpool GEW9200LQ0 manual Loading, Stopping YourDryer, Pausingor Restarting, Control Locked

Page 19

To use a Manual Cycle

Rotate the dial to select a Manual Cycle.

Press MORE TIME or LESS TIME until the desired drying time is displayed. Tap MORE TIME or LESS TIME and the time will change by 1-minute intervals. Press and hold MORE TIME or LESS TIME and the time will change by 5-minute intervals.

The initial time displayed is the actual drying time.

NOTE: The More Time or Less Time feature can be used only with Manual Cycles.

Press TEMPERATURE until the desired temperature glows.

NOTE: Pressing the Dryness Level button will cause the triple beep indicating that this option is not selectable. Also, a Dryness Level is not indicated.

Press the WRINKLE SHIELD™ feature button if this option is desired.

Press the END OF CYCLE SIGNAL button to set volume to desired level.

Press (and hold) HOLD TO START button until dryer starts (about 1 second).

While a Manual Cycle is running, you can change the settings for Time, Temperature, the WRINKLE SHIELD™ feature, and the End of Cycle Signal. Press the PAUSE/CANCEL key twice to stop the dryer and clear the settings, allowing you to select another cycle.

To unlock:

Press and hold the END OF CYCLE SIGNAL button for three seconds to turn this feature off.

NOTE: When the dryer is running and Control Locked is on, the dryer can be stopped by pressing the Pause/Cancel button, but can’t be restarted until the control is unlocked.

Loading

Properly loading your dryer can lower your utility bill and prolong the life of your garments.

Loading suggestions

Load the dryer by the amount of space items take up, not by their weight.

Do not overload the dryer. This causes wrinkling and uneven drying.

Super Capacity Plus Dryers

Heavy Work Clothes

 

4 jeans

2 sweatpants

4 workpants

2 sweatshirts

4 workshirts

 

 

 

Towels

 

10 bath towels

14 washcloths

10 hand towels

 

 

 

Mixed Load

 

3 sheets (1 king, 2 twin)

9 T-shirts

4 pillowcases

9 shorts

3 shirts

10 handkerchiefs

3 blouses

 

Stopping YourDryer

To stop your dryer at any time

Press PAUSE/CANCEL twice or open the door.

Pausingor Restarting

To pause the dryer at any time

Open the door or press PAUSE/CANCEL once.

To restart the dryer

Close the door and press (and hold) HOLD TO START button until dryer starts.

NOTE: Drying will continue from where the cycle was interrupted if you close the door and press Start within 5 minutes. If the cycle is interrupted for more than 5 minutes, the dryer will shut off.

Select new cycle settings before restarting the dryer.

Control Locked

This feature allows you to lock your settings to prevent unintended use of the dryer. You can also use the Control Locked feature to prevent unintended cycle or option changes during dryer operation.

To enable the Control Locked feature when dryer is running:

Press and hold the END OF CYCLE SIGNAL button for three seconds. The control is locked when a single beep is heard and the Control Locked status light is on.

When the dryer is off, it is not necessary to press the Control On button before activating the Control Locked feature.

Drying andCycle Tips

Select the correct cycle and dryness level or temperature for your load. If an Automatic Cycle is running, the display shows the estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Manual Cycle is running, the display shows the exact number of minutes remaining in the cycle.

Cool Down tumbles the load without heat during the last few minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level.

Drying tips

Follow care label directions when they are available.

If you use fabric softener sheets, use only ones labeled as dryer safe. Follow package instructions.

Remove the load from the dryer as soon as tumbling stops to reduce wrinkling. This is especially important for permanent press, knits, and synthetic fabrics.

Avoid drying heavy work clothes with lighter fabrics. This could cause overdrying of lighter fabrics, leading to increased shrinkage or wrinkling.

19

Image 19
Contents Use & Care Guide Electronic Electric Dryer3979274B Table of Contents Your safety and the safety of others are very important Dryer SafetyParts needed Installation InstructionsToolsandParts Optional PedestalLocation Requirements Installation clearancesDryer Dimensions Custom undercounter installation Dryer onlyCloset installation Dryer only Minimum installation spacing for cabinet installationMobile home-additional installation requirements Mobile home installations requireIt is your responsibility Electrical RequirementsElectrical Connection ElectricalConnection Wire connection Power supply cord Wire connection Direct wire Optional 3-wire connection PlanVentSystem Typical exhaust installationsOptional exhaust installations VentingRequirementsSpecial provisions for mobile home installations Alternate installations for close clearancesDetermine Vent Length Install Leveling Legs Install VentSystemLevel Dryer Remove the door Connect VentReverse Door Swing Loosen door trimInstall new handle filler and hinge cover Reinstalling the doorReverse the hinge and hinge bracket If the dryer will not start, check the following Complete InstallationStartingYour Dryer Dryer USETo use an Automatic Cycle Control Locked Pausingor RestartingLoading Stopping YourDryerCycles StatusLightsAdditional Features Drying Rack End of Cycle SignalDryer Care Cleaning theDryer LocationCleaning the Lint Screen Cleaningthe Dryer InteriorVacation and Moving Care TroubleshootingChangingthe Drum Light Stains on load or color change Dryer will not runUnusual sounds Lint on loadAccessories U.S.A Assistance or ServiceIf you need replacement parts For assistance and servicePage 3979274B Whirlpool Corporation will not pay for