Pioneer S-DV9, XV-DV9 manual Connecting up Using this unit with a Pioneer plasma display

Connecting up 02

Using this unit with a Pioneer plasma display

If you have a Pioneer plasma display (models PDP-504HDG and PDP-434HDG), you can use an SR+ cable (see note below) to connect it to this unit and take advantage of various convenient features, such as automatic video input switching of the plasma display when the input is changed.

Pioneer plasma display

	CONTROL
Media receiver	OUT

	VIDEO	IN
PR	OUT
		CONTROL
COMPONENT
VIDEO OUT		S-VIDEO
PB	Y	OUT
	VIDEO

SPEAKERS

Using the SR+ mode with a Pioneer plasma display

When connected using an SR+ cable, a number of features (such as automatic video input switching and volume muting on the plasma display) become available to make using this unit with your Pioneer plasma display even easier.

See also SR+ control options for Pioneer plasma displays on page 66 for information on setting up the unit.

1Make sure that the plasma display and this unit are switched on and that they are connected with an SR+ cable.

See Using this unit with a Pioneer plasma display above for more on connecting these components.

2To switch SR+ mode on/off, press SR+ (SHIFT + 7).

The front panel display shows the new setting; SR+ ON or SR+ OFF.

•If SR+ Error shows in the display, it means there is a communication problem between the unit and the plasma display. Check all connections and retry.

•Use a 3-ringed miniplug SR+ cable to connect the CONTROL IN jack of this unit through a media receiver to the CONTROL OUT jack of your plasma display.

Before you can use the extra SR+ features, you need to make a few settings in the unit. See SR+ control options for Pioneer plasma displays on page 66 for detailed instructions.

•The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for more information on obtaining an SR+ cable.

•You won’t be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn’t switched off.

19

En