Energy-saving design
This system is designed to use 0.5W of
electricity when power is switched to
standby.
This product incorporates copyright protection
technology that is protected by method claims
of certain U.S. patents and other intellectual
property rights owned by Macrovision
Corporation and other rights owners. Use of
this copyright protection technology must be
authorized by Macrovision Corporation, and is
intended for home and other limited viewing
uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering
or disassembly is prohibited.
For U.S. and Australia Model
C67-7-3_En
[For XV-DV9 only]
F
o
r A
ust
r
a
li
a
n
a
n
d
New Zealand models onl
y
D3-4-2-1-5
_
E
n
Voltage selector
Y
ou can find the voltage selector switch on the rear
panel of multi-voltage models.
The factory setting for the voltage selector is 220 –
230 V. Please set it to the correct voltage for your
country or region.
• For Taiwan, please set to 120-127V before using.
For Australian and New Zealand models:
The factory setting for the voltage selector is 240 V.
Please set it to the correct voltage for your country
or region.
Before changing the voltage, disconnect the AC power
cord. Use a medium size screwdriver to change the
voltage selector switch.
120-
127V
220-
230V
240V
VOLTAGE
SELECTOR
120-
127V
220-
230V
240V
VOLTAGE
SELECTOR
The channel, frequency, output power, and other features and functions of the equipment shall not be
changed after approval.
The equipment shall safely use only a channel frequency that is legally approved and shall not cause
interference on other channels. If the equipment fails to meet these requirements, use of the
equipment will be prohibited until compliance can be attained.
XV-DV9.book 4 ページ ２００４年２月２０日 金曜日 午前１１時４２分