Whirlpool GEW9200LQ0 manual Dryer Care, Cleaning theDryer Location, Cleaning the Lint Screen

Page 23

DRYER CARE

Cleaning theDryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. Clean it before or after each load. A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer’s lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. (See “Venting Requirements.”)

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Cleaningthe Dryer Interior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

3.Apply a liquid, non-flammable household cleaner to the stained area and rub with a soft cloth until all excess dye is removed.

4.Wipe drum thoroughly with a damp cloth.

5.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments which contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to prevent dye transfer.

Removing AccumulatedLint

From Inside the Dryer Cabinet

Lint should be removed every 2 years or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

23

Image 23
Contents 3979274B Electronic Electric DryerUse & Care Guide Table of Contents Your safety and the safety of others are very important Dryer SafetyParts needed Installation InstructionsToolsandParts Optional PedestalLocation Requirements Installation clearancesDryer Dimensions Custom undercounter installation Dryer onlyCloset installation Dryer only Minimum installation spacing for cabinet installationMobile home-additional installation requirements Mobile home installations requireElectrical Connection Electrical RequirementsIt is your responsibility ElectricalConnection Wire connection Power supply cord Wire connection Direct wire Optional 3-wire connection PlanVentSystem Typical exhaust installationsOptional exhaust installations VentingRequirementsDetermine Vent Length Alternate installations for close clearancesSpecial provisions for mobile home installations Level Dryer Install VentSystemInstall Leveling Legs Remove the door Connect VentReverse Door Swing Loosen door trimReverse the hinge and hinge bracket Reinstalling the doorInstall new handle filler and hinge cover If the dryer will not start, check the following Complete InstallationTo use an Automatic Cycle Dryer USEStartingYour Dryer Control Locked Pausingor RestartingLoading Stopping YourDryerCycles StatusLightsAdditional Features Drying Rack End of Cycle SignalDryer Care Cleaning theDryer LocationCleaning the Lint Screen Cleaningthe Dryer InteriorChangingthe Drum Light TroubleshootingVacation and Moving Care Stains on load or color change Dryer will not runUnusual sounds Lint on loadAccessories U.S.A Assistance or ServiceIf you need replacement parts For assistance and servicePage 3979274B Whirlpool Corporation will not pay for