JVC LVT0865-004A, XV-THV70R Introduction, Checking the supplied accessories, Important cautions

Page 7

Introduction

Notes on handling

Important cautions

Installation of the system

Select a place which is level, dry and neither too hot nor too cold between 5°C and 35°C (41°F and 95°F).

Leave sufficient distance between the system and the TV.

Do not use the system in a place subject to vibrations.

Power cord

Do not handle the power cord with wet hands!

A small amount of power (1.7 watts) is always consumed while the power cord is connected to the wall outlet (the center unit only).

When unplugging the power cord from the wall outlet, always pull the plug, not the power cord.

To prevent malfunction of the system

There are no user-serviceable parts inside. If anything goes wrong, unplug the power cord and consult your dealer.

Do not insert any metallic object into the system.

Do not apply any shock to the moving panel when it is open.

An 8 cm disc cannot be played back in this system. (Do not attempt to insert an 8 cm disc using an adaptor. Doing so will damage the system.)

Do not use any non-standard shape disc (like a heart, flower, or credit card, etc.) available on the market, because it may damage the system.

Do not use a disc with tape, stickers, or paste on it, because damage to the system may result.

Label sticker

Sticker

Paste

Note about copyright laws

Check the copyright laws in your country before recording from DVD Video, Super Video CD (SVCD), Video CD, and Audio CD discs. Recording of copyrighted material may infringe copyright laws.

Note about the copyguard system

The DVD Video discs are protected by the copyguard system. When you connect the system to your VCR directly, the copyguard system activates and the picture may not be played back correctly.

Safety precautions

Avoid moisture, water and dust

Do not place the system in moist or dusty places.

Avoid high temperatures

Do not expose the system to direct sunlight or do not place it near a heating device.

When you are away

When away on travel or otherwise for an extended period of time, remove the plug from the wall outlet.

Do not block the vents

Blocking the vents may damage the system.

Care of the cabinet

When cleaning the system, use a soft cloth and follow the relevant instructions on the use of chemically-coated cloths. Do not use benzene, thinner or other organic solvents including disinfectants. These may cause deformation or discoloring.

• Do not clean the moving panel when it is open.

If water gets inside the system

Turn the system off and remove the plug from the wall outlet, then call the store where you made your purchase. Using the system in this state may cause a fire or electrical shock.

Checking the supplied accessories

Check to be sure you have all of the supplied accessories. The number in the parentheses is the quantity of the pieces supplied.

If anything is missing, contact your dealer immediately.

Remote control (1)

Batteries (2)

Stand (1) (for the center unit)

Legs (2) (for the stand)

FM antenna (1)

AM (MW) loop antenna (1)

Power cord (1)

System cord (1)

Video cord (1)

Speaker cords

5 m (3): For the left front speaker, right front speaker, and center speaker

10 m (2): For the left rear speaker and right rear speaker (The length of the above speaker cords are approximate.)

Speaker wall brackets (2)

Screws

For the stand (1)

For the speaker wall brackets (2)

Paper pattern (1) (for attaching the center unit to a wall)

2

Image 7
Contents Consists of XV-THV70R, SP-PWV70, SP-XSV70, and SP-XCV70 TH-V70RIf in Doubt Consult a Competent Electrician Important for Laser Products Above ALL Page Table of Contents Important cautions Checking the supplied accessoriesSafety precautions IntroductionRear panel Names of parts and controlsCenter unit Front panelDisplay window Powered subwooferFront Powered subwoofer Display windowRemote control Remote controlNames of parts and controls ALL About discsPlayable disc types PALPlayback Control function PBC High-resolution still image displayAbout discs Disc structureGetting started Setting the DISP.SET selectorWhen placing the center unit vertically When placing the center unit HorizontallyFor connections, see pages 10 to When placing the center unit verticallyGetting started Attach the legs to the standConnections Connecting a TVTo connect a TV without the Scart connector To connect a TV with the Scart connectorAM MW loop antenna Connecting the FM and AM MW antennasFM antenna Speaker layout Connecting the powered subwooferConnecting the satellite speakers Powered subwooferConnecting the speaker cord to the powered subwoofer Connecting the satellite front, center, rear speakersBefore connecting the speaker cord Connecting the speaker cord to the satellite speakersConnecting to a digital component Connecting to an analog componentRCA pin plug cord To audio output Connecting the power cord Attaching speakers to the brackets Installing the equipment on the wallWhen attaching the rear speakers to a wall When attaching the AM MW loop antenna to a wallExample of attachment When attaching the center unit to a wallPage Replace the cover Using the remote controlPutting batteries in the remote control Operating the system from the remote controlTry to operate your TV by pressing TV Using the remote control for TV operationsSetting the remote control signal for operating your TV Release TVBasic operations Press Audio to turn the power on Press to turn the power onTurning on/off the system Press Volume + or -. Press VOL + or Adjusting volumeSelecting the source to play Press Muting To restore the soundBasic operations Turning off the sound temporarilyPress Sleep Adjusting the brightnessTurning off the power with the timer Press DimmerSubwoofer + Changing the decode modePhase setting Setting the subwooferVolume control Turn Volume knobPreventing screen burn-out with the screen saver When the center unit is placed horizontally, pressBasic playback Inserting and removing a discStopping playback temporarily Starting playback again Basic playbackStopping playback completely Moving back the playback position during DVD playbackSearching for a particular point Locating a desired selection using Number buttonsLocating the beginning of a desired chapter or track Tuner operations Tuning in to stations manuallyUsing preset tuning To store the preset stationsTo tune in to a preset station Selecting the FM reception modeReducing the noise of AM MW broadcast Tuner operations Using the RDS Radio Data System to receive FM stationsWhat information can RDS signals provide? To show the RDS signalsPTY Search To search for a program using the PTY codesSearching for a program by PTY codes Press PTY Search while listening to an FM stationTA News Info TA/NEWS TA/INFO Switching to broadcast program of your choice temporarilyTest TA/NEWS/INFOCase How the Enhanced Other Network function actually worksDTS Digital Surround Digital signal format indicators on the display windowCreating the realistic sound fields Dolby SurroundCreating sound field Available Surround modes for each input signalDAP Digital Acoustic Processor modes All Channel Stereo All Channel Stereo reproductionCreating the realistic sound fields Selecting the surround modePress Test again to stop the test tone Using DAP Modes and All Channel StereoAdjust the speaker output levels -10 dB to +10 dB Adjust the speakers output levels -10 dB to +10 dBShowing the on-screen bar Using the on-screen barContents of the on-screen bar Advanced operationsPress Cursor ∞/5 to select the desired option Basic operation through the on- screen barChanging the time information Press on Screen twicePress TOP Menu or Menu Advanced operationsLocating a desired scene from the disc menu Locating a desired scene from the DVD menuPress Angle repeatedly to select the desired view angle Selecting a view angle of DVDSelecting a view angle Press AngleShowing all view angles on the TV Changing the subtitle languages and audio languagesSelecting the subtitle language On-screen bar appears on the TV screen Selecting the audio languagePress Audio Press Audio repeatedly to select the desired audio languageST 1 ST 2 L 1 R 1 L 2 R Selecting the audio channelPress Cursor ∞/5 to select the desired audio language Press Audio repeatedly to select the desired audio channelCursor and Enter button Playing from a specified position on a discLocating a desired chapter from the on-screen bar Press Cursor ∞/5 to select the desired audio channelsPress Digest Locating a desired position by specifying the timeLocating a desired scene from the digest display Use Number buttons 0-9 to enter the timeFrame-by-frame playback Special picture playbackShowing continuous still pictures Press Zoom + or Playing back in slow-motionZooming in/out Press ¡ orRepeat steps 2-5 to adjust other parameters Changing the VFP settingPress Cursor 3/2 repeatedly to select the VFP mode To adjust User 1 or UserRepeat to program the next steps Changing the track orderPlaying back in the desired order Playing back tracks in random orderRepeating a desired part Press Cursor ∞/5 repeatedly to select the repeat modeRepeat playback Repeating a current title, chapter, or all tracksAs many times as required MP3 disc playbackBasic operations Insert an MP3 discOperations Operations through the MP3 control displayMP3 control display 01 / 14 TotalPress Zoom + or while the slide-show is paused. See also Jpeg disc playbackSlide-show Insert a Jpeg discPress Menu Operations through the Jpeg control displayJpeg control display Press Number buttons 0-10, +10 to enter the file numberUsing the choice menus Setting DVD preferencesChoice menus Desired option Basic procedure through the choice menusChoice button Language menu Setting DVD preferencesLanguage codes list Items Contents and guidelinesMP3/JPEG Picture menuMonitor Type Screen SaverAudio menu Size menu SPK. Setting menuDistance menu Level menuOthers menu Cursor Enter buttons Setting Parental LockRestricting playback by Parental Lock ChoiceReleasing Parental Lock temporarily Changing the setting of Parental LockPress Number buttons 0-9 to enter your password New setting is storedCountry/Area codes list for Parental Lock Repeat steps 2 and 3 to set other items Setting the system through the display windowPress Setting Press Cursor 2/3 to make an adjustmentTry to operate your VCR by pressing VCR Setting the remote control signal for operating yourOperating other manufacturers’ VCR Release VCRHandling Discs MaintenanceCleaning the system General NotesGeneral TroubleshootingDVD Playback Others TroubleshootingMP3 Playback Jpeg PlaybackRefers to individual chapters included in a title GlossarySpecifications Total harmonic distortion Amplifier sectionFront/Center/Rear At 1 kHz, with 10 %0402TMMMDWJEM