If dryers do not
operate properly...
Check the following to be sure that:
1.Electrical supply is connected.
2.Circuit breakers are not tripped or fuses blown.
3.Doors are closed.
4.Timer has been actuated,
5.Controls are set in a running or “ON” position.
6.Gas shutoff valves are open both on dryer and supply line.
Move dryers to a
new location...
Floor Damage
Slide dryers onto cardboard or hardboard before moving across floor.
Failure to do so may result in damage to floor covering.
l Shut off electric supply to dryers.
l Disconnect power supply cords. Tape securely to dryer.
l Shut off the gas supply valves in the gas supply line.
l Disconnect gas pipe and fittings from dryer and cap the gas supply line. Tape end of dryer gas pipes.
l Tape the drums to the front panel. l Tape doors.
l Adjust leveling legs all the way in.
Before installing dryers in a new location, check with your gas supplier or dealer to see that your dryer is equipped with the correct burner for the particular type of gas in your new building. Burner information may be found on the rating plate in the door well of the dryer.
If you need
assistance...
The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining your dryers not covered in the Installation Instructions. The Whirlpool Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial
When you call, you will need the dryer model number and serial number. Both numbers can be found on the serial/rating plate located in the door well behind the dryer door and on the front of the opening.