Before you start...
Check location where dryers will be used. Proper installation is your responsibility The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Make sure you have everything necessary for correct installation.
Each of the dryers is equipped with a timer, selector switches and indicator lights. The timers are set to provide 45 minutes (4 pins) of drying time when activated by the coin slide. Timer cams for
The
Fire Hazard
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life.
-Do Not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
-WHAT TO DO IF YOU SMELL GAS:
l Do Not try to light any appliance.
l Do Not touch any electrical switch; Do Not use any phone in your building.
l Clear the room, building or area of all occupants.
l Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
-If you cannot reach your gas supplier, call the fire department.
-Never install dryer up against draperies or curtains or on carpet.
-Keep any and all items from falling or collecting behind the dryer.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Post this warning in a prominent location.
It is recommended that the operator post, in a prominent location, instructions for the customer’s use in the event that the customer smells gas. This information should be obtained from your local gas supplier.
Protection from weather: Proper operation requires temperatures above 45°F (7.2”C).
The wiring diagram is located inside the control panel and access panels.
Support: The floor must be able to support the total weight of 3 15 pounds per unit.
Level floor: Maximum floor slope under dryers - 1 inch.
Fire Hazard
l If you install dryers in a garage, carport, or areas near vehicles where fumes from gasoline or other vapors may be present, the vapors may be heavier than air and remain near the floor. Place dryers a minimum of 18 inches above floor. Check with your building inspector regarding requirements for this installation.
Failure to follow these instructions could result in a fire or explosion.
Important: Observe all governing codes and ordinances.
requirements,” Page 3.
ded electrical outlet is
requirements,” Page 4.
Location must be large enough to fully open dryer doors. See Page 7 for recessed area requirements and product dimensions.
Electrical Shock Hazard It is the customer’s responsibility:
l To contact a licensed electrician.
. To have dryers installed according to all national and local codes and ordinances.
Failure to do so could result in a fire, electrical shock or other personal injury.
Personal Injury Hazard
More than one person is required to lift, tilt, or move the dryers because of their weight and size.
Failure to follow these instructions may result in personal injury.
Page 2