Recessed area and closet Installations
Fire/Health Hazard
Exhaust dryers to the outside to prevent exposure to substances in the gas fuels and combustion byproducts which may be harmful to your health.
Failire to do so may result in a fire or health hazard.
L
This appliance may be installed in a recessed area.
The installation spacing is the minimum allowable. Additional spacing should be considered for ease of installation, servicing and compliance with local codes and ordinances.
If closet door is installed, the minimum unobstructed air openings in the top and bottom are required. Door must have two centered openings as illustrated. Both openings must provide a minimum of 72 square inches of unobstructed airflow as shown. Louvered doors with equivalent air openings are acceptable.
FOR CLOSET INSTALLATIONS, TO PREVENT LARGE AMOUNTS OF LINT AND MOISTURE FROM ACCUMULATING, TO MAINTAIN DRYING EFFICIENCY, AND TO PREVENT EXPOSURE TO POSSIBLE HEALTH HAZARDS, DRYERS MUST BE EXHAUSTED OUTDOORS.
+
4
0”
Additional clearances may be required for wall. door and floor moldings if external exhaust elbow is used.
Recessed front view
|
| Closet | view |
|
|
Side | view |
|
|
| |
|
|
| Additional |
| |
Additional | clearances | for | |||
space | may | wall, | door | and | |
be | needed | floor | moldings | ||
for | exhaust | may | be |
| |
elbow. |
| required. |
| ||
I- 7”
Opening is minimum for closet door. Louvered door with equivalent air openings is acceptable.
Front view
Companion appliance spacing should be considered.
No other
Product dimensions
Side view
r
approx.
Rear view
pJ
llB/ kttom exhaust
To change to a 30- or 60-minute timing cam
Electrical Shock Hazard
Disconnect both power supply cords from the electric power supply before making these changes. Change timing cams before completing electrical connection.
Failure to follow these instructions may result in electrical shock or personal injury.
Each dryer is equipped with a 45 minute timer cam that provides 45 minutes of drying time when activated by the coin slide.
You can install the
1.Unlock control panel. Lift up and rotate out from cabinet. Control panel WIII STIIIDe attached to cabinet.
2.Reach into control panel area. Use a Phillips screwdriver to loosen (but not remove) timer mounting bracket screw. Lift up to remove timer assembly and bracket from cabinet.
ratchet tooth
3.Turn the timing cam by hand until the
Page 7