4.insert a narrow,
5.Place new cam (hub side down) over clock shaft. tine up flat side of shaft with flat side of cam hole. Check that drive lug is in place.
6.Turn cam until
7.Press cam down in place on motor shaft. Make sure that ‘V’- shaped notch clears the ratchet tooth.
8.Reattach the timer bracket assembly; then tighten the screws.
9.Repeat steps for other timer.
10.Close and lock the control panel.
Page 10
Now start.. .
IWith dryers in laurldry area.
Il.
Check that each leg is
approximately 1 inch frc)rn base.
‘2.
Wipe the Interior of the drums thoroughly with a damt ) cloth.
:3.
Install coin vaults and Iccks (not supplled) into meter cc se openings.
14= .
| Install control | panel lot < and key | |||
| (not supplied). |
|
| ||
! |
|
|
|
|
|
| L |
|
|
|
|
| Electrical | Shock | I iazard | ||
| ~~ |
|
| ||
| ‘Control |
| p&e1 | m&t | b4 I closed |
| and locked at all time s. | ||||
| I |
|
|
|
|
| Failure to do so could result in | ||||
| serious | injury or death . | |||
I |
|
|
| ||
|
|
|
|
| |
If you wish to change tt e 45minute dryer timing cams to eit >er 3@ or 60- minute timlng cams, set I ‘To change to a 3C- or 6Uminute tin ling cam,’ Page 9. Complete all 01 the steps given In that section be’ore going to Step 6.
Electrical Shock I iazard
Dlsconnect electrka I power at the service panel (fu ;e box or clrcult box).
Fallure lo do so coulc I result In serious Injury or deat 1.
6.
Open control panel and rest It on the bottom edge of the opening. Attach slide extension (with flange pointing down) to one of the coin- slide mechanisms. Insert the coln- slide mechanism through the opening to left of the control panel.
Secure coin slide mechanism from itide the control panel using the 3/l 6’ bolt and wast included with the slide mechanism. Install coin box.
8.
Repeat Steps 6;and 7 for the other coin slide mechanism. Close control
pan
911r.
Insert top of wire guard Into holes on each side of the coin slide
mechanism. Insert screws through hooked ends of guard and tighten. Repeat for other wtre guard.