Miele W 1986 Adding/removing laundry during a wash program, Drum door can not be opened if

Page 18

Using the washer

Adding/removing laundry during a wash program

You can interrupt the following pro- grams to add or remove a piece of laundry:

–COTTONS

–PERMA PRESS

–Jeans

–Dress Shirts

–Starch

^Press the "Door" button and open the drum door.

^Add or remove the piece of laundry.

^Close the door.

The program will automatically con- tinue.

The drum door can not be opened if:

–the water temperature is greater than 55°C.

–the water level is too high.

–the electronic program lock is acti- vated.

–the program has reached the final spin cycle.

If you press the "Door" button during any of these conditions the "Door Lock" indicator will light.

Cancelling a program that has not yet started

^Turn the program selector to "End".

^Once the "Time remaining" display goes blank turn the program selector to the new program.

18

Image 18

Contents Operating instructions Contents Installation instructions Important Safety Instructions Guide to the washer Control panelBefore using the washer Using the washer Prepare and sort laundryLoad the laundry Dress shirts Select a programJeans Fine rinseProgram guide Fabric CottonsSelect a spin speed Special spin optionsSelect wash options if needed Add detergent Detergent Water softenerDo not use chlorine bleach Water hardness Starch Using the Starch programFabric softener Fabric dyeSelect Delay Start Start the programActivate the program lock if necessary Unload the laundry Remove the laundryCancelling a program that has not yet started Adding/removing laundry during a wash programDrum door can not be opened if Skipping part of a program Cancelling a program that has startedMaking changes to the pro- gram To change a programElectronic program lock To cancel the program lockLocking the washer To activate the program lockChild Safety Lock To activate the safety lockTo deactivate the safety lock Cleaning the washer Cleaning the detergent drawerWasher care Cleaning the drain pump and lint trap After cleaning Quick Guide Load the laundry Quick GuidePrepare and sort laundry Select a programActivate the program lock if necessary Select Delay Start if needed Start the programSelect wash options if needed Add detergent Unload the laundryProgram guide Cleaning the water inlet filters Cleaning the inlet hose filterCleaning the filter in the inlet valve Frequently asked questions Program stops and a fault indicator blinksProgram will not start Program runs normally but a fault indicator lights up Poor wash results There is white deter What if … Possible cause Fix Laundry has aGray sticky residue? Gent residue onDoor will not open when the Door button is pressed Opening the drum door during a power failure After Sales Service PC UpdateInstallation Instructions Plumbing connection InstallationHelp protect our environment Electrical connectionHelp protect our environment Disposal of the packing materialsDisposal of an old appliance Installation Front viewInstallation site Installation beneath a counter Washer / Dryer StackInstallation Remove the shipping strutsInstallation Adjust the four leveling feet Level the washerPlumbing connection Water connectionPlumbing connection Connection to the drain system Electrical connection Grounding InstructionsPage Page Alterations rights reserved /000/1302