Miele W 1986 operating instructions Frequently asked questions, Program will not start

Page 30

Frequently asked questions

With the following guide, minor problems can be fixed without a service call.

The program will not start.

What if …	Possible cause	Fix
the program indicator	The washer has no	Check whether:
"Anti-crease/End" does	power.	– it is plugged in.
not light, or the START		– if the circuit breaker
button does not blink?		– if the circuit breaker
button does not blink?		has tripped.
		has tripped.
the "Door Lock" indica-	The lock function is acti-	Deactivate the lock
tor blinks?	vated.	function.
The program stops and a fault indicator blinks.

What if...?	Possible cause	Fix
the buzzer sounds, and	The drain is blocked.	Clean the drain filter and
"Check drain" blinks.		the drain pump.
"- - -". appears in the	The drain hose is too	The maximum drain
display?	high.	pump height is 3 ft.
the buzzer sounds, and	The water inlet is blocked.	Open the water valve.
"Water intake" blinks.
"- - -". appears in the
display?
the buzzer sounds, and	There is a fault.	Restart the program.
either the "Pre-wash" or		If the fault message
"Rinses" indicators of		appears again call
the sequence display		Miele’s Technical Service
blink.		Department.
"- - -". appears in the
display?

*To turn off the fault indicator light: Turn off the washer with the "On/Off" button and turn the program selector to "End".

26

Image 30

Contents Operating instructions Contents Installation instructions Important Safety Instructions Guide to the washer Control panelBefore using the washer Using the washer Prepare and sort laundryLoad the laundry Dress shirts Select a programJeans Fine rinseProgram guide Fabric CottonsSelect a spin speed Special spin optionsSelect wash options if needed Add detergent Detergent Water softenerDo not use chlorine bleach Water hardness Starch Using the Starch programFabric softener Fabric dyeSelect Delay Start Start the programActivate the program lock if necessary Unload the laundry Remove the laundryCancelling a program that has not yet started Adding/removing laundry during a wash programDrum door can not be opened if Skipping part of a program Cancelling a program that has startedMaking changes to the pro- gram To change a programElectronic program lock To cancel the program lockLocking the washer To activate the program lockChild Safety Lock To activate the safety lockTo deactivate the safety lock Cleaning the washer Cleaning the detergent drawerWasher care Cleaning the drain pump and lint trap After cleaning Quick Guide Load the laundry Quick GuidePrepare and sort laundry Select a programActivate the program lock if necessary Select Delay Start if needed Start the programSelect wash options if needed Add detergent Unload the laundryProgram guide Cleaning the water inlet filters Cleaning the inlet hose filterCleaning the filter in the inlet valve Frequently asked questions Program stops and a fault indicator blinksProgram will not start Program runs normally but a fault indicator lights up Poor wash results There is white deter What if … Possible cause Fix Laundry has aGray sticky residue? Gent residue onDoor will not open when the Door button is pressed Opening the drum door during a power failure After Sales Service PC UpdateInstallation Instructions Plumbing connection InstallationHelp protect our environment Electrical connectionHelp protect our environment Disposal of the packing materialsDisposal of an old appliance Installation Front viewInstallation site Installation beneath a counter Washer / Dryer StackInstallation Remove the shipping strutsInstallation Adjust the four leveling feet Level the washerPlumbing connection Water connectionPlumbing connection Connection to the drain system Electrical connection Grounding InstructionsPage Page Alterations rights reserved /000/1302