40003324.qxd 28/06/2006 13:00 Page 16
Operation
1.Open the door and load the drum with laundry. Ensure that garments do not hinder closure of the door.
2.Gently close the door pushing it slowly until you hear the door 'click' shut.
3.Ensure that the water tap is ON.
4.Press the 'On/Off' button to switch on the dryer. The On/Off indicator will light up and the programme number will be indicated.
5.Turn the Programme Selector dial to select the required drying programme (see Programme Guide).
6.If drying synthetics, acrylics or delicate items, press the Acrylics/Synthetics button to reduce the heat level. The light above the push button will light up when the machine is in low heat setting. To deselect this status the machine must be reset.
7.Press the 'START' button. The dryer will start automatically and the 'Time to End' indicator will be continuously lit. The time to the end of the program will be shown on the display.
8.The display will show the drying progress in terms of time remaining, the time to end indicator will remain lit.
9.If the door is opened during the programme to check the laundry, it is necessary to press START to recommence drying after the door has been closed.
10.When the Display shows 15' the machine will enter the cool down phase, the clothes will be tumbled in cool air allowing the load to cool down.
11.When the programme is complete the Display will show 0'min. and the buzzer will sound for 10 seconds.
12.Following completion of the cycle the buzzer will sound and the drum will rotate every 10 minutes. This will continue until the machine is reset or switched OFF.
WARNING!
The drum, door and load may be very hot.
Cancelling and resetting the programme
To cancel a programme press the START/RESET button for 5 seconds. The machine will indicate that it has been reset by the indicators flashing. It is possible to change the programme within the first 10 minutes without using the cancel and reset function.
Start Delay Function
The Delay Start function allows the user to delay the start of the drying cycle by up to 23 hours.
When the function is first selected the display will show a delay of 1 hour, subsequent presses of the button will increase the delay by 1 hour to a maximum of 23 hours.
To commence the programme press START and the display will indicate the hours remaining on the time delay and will complete the drying cycle at the end of this time.
Note: If START is not pressed within 5 seconds the Delay Start will cancel automatically.
16