Connection of the machine to the drain

40003324.qxd 28/06/2006 12:59 Page 9

Connecting to the cold water supply

The machine has an inlet hose with a 19mm (3/4") threaded ferrule fitted to the end. This hose is provided to connect the cold water supply to the machine.

If your cold water supply is shared between the dryer and a washing machine use the Y connector provided to split this supply.

Only use the new hose supplied with the machine.

Do not re-use old hoses which are attached to existing installations.

Do not over-tighten the connections. Hand tight is sufficient. Do not trap or kink the hose.

1.Check the hose connection to the machine, ensuring that it is hand tight.

2.Connect the straight end of the hose to the cold water supply; ensure that there are no kinks.

3.Turn on the water supply and check for leaks. If there is a leak, turn off the water supply, disconnect the hose and check the sealing washers are in place. Refit the hose and turn on the water supply.

Connection of the machine to the drain

This machine must be connected in accordance with the water supply regulations. Water byelaws prohibit connection to a surface water drain.

Decide which plumbing option suits you best then follow the instructions below.

Option 1

Waste pipe connection (waste trap)

After removing the blanking plug or cutting the membrane from the waste system, securely fix the outlet pipe to the drainage system using a hose clip.

sink

flexible

discharge hose

hose clip

trap with hose

adaptor

All machines are tested

with water prior to

leaving the factory so

a small amount of

water may remain in

the drain hose.

Flooding could occur if

any part of the

installation is not

completed correctly.