840101400 ENv02.qxd 5/10/02 1:28 PM Page 6
Features (cont.)
Retractable Cord | Cord |
1. Press and hold the Cord Release | Release |
Button while pulling cord to desired | Button |
| |
length. Do not unwind cord beyond |
|
the tape indicator on the cord. |
|
2. To store cord, place the iron, soleplate |
|
down, on ironing board. Unlatch |
|
Retractable Cord Handle and wind |
|
clockwise. |
|
IMPORTANT! Do not press Cord | Wind |
Release Button while winding cord. | clockwise |
Only wind clockwise or the cord may |
|
jam. See illustration. |
|
3. If cord jams while winding, push the |
|
Cord Release Button to unwind slightly |
|
until cord is free. Then slowly start to |
|
wind clockwise again. |
|
Caring for Your Iron
Iron
1.The water tank of your iron should be emptied after each use. Turn Temperature Control Dial to Off. Unplug the iron and hold over a sink. Slowly tilt pointed end of iron down over sink. Water will run out of water tank opening.
2.After iron has completely cooled, store in an upright posi- tion. Do not store iron laying flat on soleplate.
Soleplate
1.Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the soleplate.
2.To clean occasional
3.Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any
If Retractable Cord Handle comes off, it is designed to snap back in place.
1.Place pins of handle into slots in reel. See illustration.
2.Lift handle up until it snaps in place.
Retractable |
Cord Handle |
1.Fill iron with water.
2.Plug in iron. Turn Temperature Control Dial to the highest temperature.
3.Let iron heat for 3 minutes.
4.Turn Temperature Control Dial to OFF. Unplug iron and hold over a sink with the soleplate facing down.
5.Turn Adjustable Steam Switch to Full Steam 
. Hot water and steam will flow out of the steam vents. Press the Blast Button several times to increase cleaning.
6.Allow all water to drain from iron then let cool and store.
6 | 7 |